Item Description：
Vehicle Location : Liftgate
Extended Length [in] : 19.30"
Compressed Length [in] : 13.62"
Patented Multi-Lobe Seal makes gas spring more tolerant to vibration and temperature extremes
Twin Tube internal construction-Premium gas-charged cylinders
Direct fit,Ensures easy installation and precise operation
Individually tested for performance and reliability
Brand new and warranty offered!!!
fit the Following Vehicle：
for 2005-2012 Nissan Pathfinder Base Sport Utility 4-Door Liftgate
for 2005-2012 Nissan Pathfinder LE Sport Utility 4-Door Liftgate
for 2005-2012 Nissan Pathfinder S Sport Utility 4-Door Liftgate
for 2005-2012 Nissan Pathfinder SE Off-Road Sport Utility 4-Door Liftgate
for 2005-2012 Nissan Pathfinder SE Sport Utility 4-Door Liftgate
for 2005-2012 Nissan Pathfinder XE Sport Utility 4-Door Liftgate
How to Properly Install a standard Lift support？
1. Use Safety stands whenever a procedure requires you under the vehicle or supports. Or have someone hold the lid open for you so that they can raise or lower it as needed.
2. Before removing the old lift support,inspect the end connections and compare them to the units on your vehicle to make sure that they are the same As well as the extended length.
3. Remove the old support from the vehicle by placing a small flat headed screw driver under the U shaped band on the ends of the support. Slowly turn the screw driver and it will lift up on the band approx.1/8",then pull the support away from the vehicle and it will release.
4. To install the new supports do the same procedure in reverse. DO NOT jam the new support end over the ball socket without lifting the U band slightly or damage may occur.
5. Lift Supports need to be installed fully extended. In most cases you just can't compress them unless they are on the vehicle. If you have any issues during the installation PLEASE contact us. Never force a support.
6. If the ends are not lining up the support may need to be turned. To do this attach the shaft end of the support to the vehicle and then turn the entire body of the support clockwise unit the ends line up.
