Collecting listings has surprises
Description The screw terminals are typical for these types of bare amps and are a little weak (so don't over tighten, or solder on some wires). The line level input connector is a standard 1/8" stereo connector, the power and speaker connections use CMM5-2 PCB screw down terminals. It has a large heat sink and it never shutdowns from overheating. The board design is quite simple as most of the work is done by the ST Microelectronics 7377 integrated circuit.
This is a amplifier.
Feature
- Color: As shown
- Material: PCB
- Size: 5.2x4.8x4cm/2.0x1.9x0.9inch
- Note: It has no case and it doesn't come with a power supply.
- Output Power: 15W+15W
- Blue LED indicator will light on when amplifier power on.
- Chip: TDA7297 Dual-Channel Amplifier Chip
- Dual output channel of 15W+15W; can be connected to 4 to 8 ohms/ 10 to 50W speakers.
- The only control is for volume, and it is static free when adjusted.
- Efficiency: up to 90%
- Output Impedance:4-8 ohms
- Power Supply: 9-18V, Recommend 12V 2A
- The volume control is precise and smooth and the speaker connector is a bit lightweight.