Shoei Z-Two (Z-II) Motorcycle Helmet Size XXLarge, Axis Yellow

• Fiberglass Composite Material (FCM) shell.
• Two shell and four EPS liner sizes for a more comfortable fit.
• Large eye-port opening for greater visibility.
• Molded rear tail fin to reduce lift, drag and wind noise.
• Recessed adjustable forehead and rear exit vents positioned for optimum ventilation.
• Mesh shielded chin vent. Built in neck roll exhaust vent.
• Adjustable anti-fog chin vent.
• Breath Chamber System uses negative air pressure to pull heat and moisture (caused by breathing) out through a cavity in the   chin bar.
• EPS liner.
• Every component was designed to achieve the lightest helmet possible while still incorporating all the features demanded by serious enthusiasts.
• Thermo Molded 3D liner system matches liner perfectly to helmet interior for maximum comfort and fit. Special relief for riders who wear glasses.
• The entire interior liner (cheek pads, upper liner and chin strap cover) is easily removed to allow cleaning.
• Chin Strap clip neatly secures chin strap.
• QRBP (Quick Release Base Plate) allows tool-less shield removal and eliminates side covers for a flush, quiet fit.
• 3 Dimensionally curved shield (CX-1) for optical clarity.
• Scratch resistant shield coating.
• Adjustable Base Plates insure  "Air Tight" fit of shield to helmet.
• 100% protection from harmful UV A & B rays.
• One-piece injection molded for consistent fit.
• Optional (CF-1) racing shield with tear-off posts.
• Snell M2000 (date of manufacture is 04/03) and DOT approved.

Sizing Information

   XX-Large helmet fits heads 63cm to 64cm (24¾"-25¼") in circumference.

Snell Ratings

       Before I purchased helmets for my own use, I did some research on the difference between the Snell M2000 and

 M2020 standards.  They are nearly identical, line-for-line.  You can check the specifications yourself at http://www.smf.org/

What's Included

     Listing includes a Shoei Z-Two helmet in axis yellow (size xx-large) with clear shield, Shoei helmet bag, chin curtain, breath guard, and box. 

     This is an older helmet, but since the interior padding has been replaced with quality foam, fit and safety should not be compromised.  ckeek pads sldo have new foam on the inside (next to the fabric).  As you can see in the photos, the fabric is in near-new condition as are the strap covers.  Also shown in one of the photos, I have 'relieved' the EPS a little in the front and rear to give me a little more room front-to-back.  Still plenty of EPS left in case of a crash.If you're not ready to spend $600-plus for a Shoei helmet, this may be a good option for you.   I also have available a genuine Shoei shield in Light Smoke in near-new condition, as well as a clear (with a couple of scratches near the top) and would make you a great deal on either (or both).

 NOTE:   This helmet had an intercom installed (since removed) so I removed some of the EPS to accommodate the speakers.  The voids have been filled with the same foam as the headliner and cheek pads.  I'll leave the front EPS loose (it's pretty secure as it is) in case you want to install your own intercom (Shoei had held it in place in two locations with silicone adhesive).

Conditions of Sale

     Items are guaranteed to be as described; no other warranty