Open Boxed never used.
--------------------------------------------------
Key Features
• Support Hyper-Speed
1. Dual socket R (LGA 2011) supports
Intel® Xeon® processor E5-2600
and E5-2600 v2 family†
2. Intel® C602 chipset; QPI up to 8.0GT/s
3. Up to 1TB ECC DDR3, up to 1866MHz;
16x DIMM slots
4. 2 PCI-E 3.0 x16, 3 PCI-E 3.0 x8,
1 UIO PCI-E 3.0 x8 (for SMCI UIO HBA)
or 1 PCI-E 2.0 x4 (in x8)
5. Intel® i350 Dual port GbE LAN
6. 8x SATA2 and 2x SATA3 ports
7. Integrated IPMI 2.0 and KVM with
Dedicated LAN
8. Dual port front and rear USB 3.0
9. Performance boost with Hyper-Speed
Physical Stats | ![](https://www.supermicro.com/a_images/boxes/line_yellow.gif) | Form Factor | | Dimensions | - 13.68" x 13" (34.74cm x 33cm)
|
| Processor/Cache | ![](https://www.supermicro.com/a_images/boxes/line_yellow.gif) | CPU | - Intel® Xeon® processor E5-2600
and E5-2600 v2 family† (up to 150W TDP **) - Dual Socket R (LGA 2011)
| Cache | | System Bus | | Note | † BIOS version 3.0 or above is required | Note | ** Motherboard supports this maximum TDP. Please verify your system can thermally support |
| System Memory | ![](https://www.supermicro.com/a_images/boxes/line_yellow.gif) | Memory Capacity | - 16x 240-pin DDR3 DIMM slots
- Up to 1TB DDR3 ECC LRDIMM
- Up to 512GB DDR3 ECC RDIMM
- Up to 128GB DDR3 ECC/non-ECC UDIMM
| Memory Type | - 1866/1600/1333/1066/800MHz* ECC DDR3 SDRAM 72-bit, 240-pin gold-plated DIMMs
- Support ECC and non-ECC UDIMMs
* Maximum memory speed may be capped by CPU. Please verify that the chosen CPU can support desired memory speed.
| DIMM Sizes | - 32GB, 16GB, 8GB, 4GB, 2GB, 1GB,
64GB LRDIMM
| Memory Voltage | | Error Detection | - Corrects single-bit errors
- Detects double-bit errors (using ECC memory)
|
| On-Board Devices | ![](https://www.supermicro.com/a_images/boxes/line_yellow.gif) | Chipset | | AHCI SATA | - SATA 2.0 3Gbps with RAID 0, 1, 5, 10
- SATA 3.0 6Gbps with RAID 0, 1, 5, 10
| SCU SATA | - SATA 2.0 3Gbps with RAID 0, 1, 5, 10
| IPMI | - Support for Intelligent Platform Management Interface v.2.0
- IPMI 2.0 with virtual media over LAN and KVM-over-LAN support
- Nuvoton WPCM450 BMC
| Network Controllers | - Intel® i350 Dual Port Gigabit Ethernet
- Virtual Machine Device Queues reduce I/O overhead
- Supports 10BASE-T, 100BASE-TX, and 1000BASE-T, RJ45 output
- 1x Realtek RTL8201N PHY (dedicated IPMI)
| Video | | Audio | - RealTek ALC889 7.1 High Definition Audio with S/PDIF header
|
| Input / Output | ![](https://www.supermicro.com/a_images/boxes/line_yellow.gif) | AHCI SATA | - 2x SATA 3.0 ports (6Gbps)
- 4x SATA 2.0 ports (3Gbps)
| SCU SATA | - 4x SATA 2.0 ports (3Gbps)
| LAN | - 2x RJ45 Gigabit Ethernet LAN ports
- 1x RJ45 Dedicated IPMI LAN port
| USB | - 4x USB 3.0 ports (2 rear + 2 via header)
- 7x USB 2.0 ports total
(4 rear + 2 via header + 1 Type A)
| Audio | - Line-in / Line-out / Microphone Ports
| Serial Port / Header | - 1x Fast UART 16550 Header
| IEEE 1394a | | DOM | - 1x DOM (Disk on Module) power connector
| TPM | |
|
SuperServer(s) with X9DAX-iF |
![](https://www.supermicro.com/a_images/boxes/line_yellow.gif) |
Model(s) | |
|
Expansion Slots |
![](https://www.supermicro.com/a_images/boxes/line_yellow.gif) |
PCI-Express | - 2x PCI-E 3.0 x16
- 3x PCI-E 3.0 x8
- 1x UIO PCI-E 3.0 x8 (for SMCI UIO HBA) or 1x PCI-E 2.0 x4 (in x8)
(Both CPUs need to be installed for full access to PCI-E slots and onboard controllers. See manual block diagram for details.)
|
|
System BIOS |
![](https://www.supermicro.com/a_images/boxes/line_yellow.gif) |
BIOS Type | - 128Mb SPI Flash EEPROM with AMI BIOS
|
BIOS Features | - Plug and Play (PnP)
- APM 1.2
- PCI 2.3
- ACPI 1.0 / 2.0 / 3.0 / 4.0
- USB Keyboard support
- SMBIOS 2.7.1
- UEFI 2.3.1
|
|
Management |
![](https://www.supermicro.com/a_images/boxes/line_yellow.gif) |
Software | |
Power Configurations | - ACPI / APM Power Management
- Power-on mode for AC power recovery
|
|
PC Health Monitoring |
![](https://www.supermicro.com/a_images/boxes/line_yellow.gif) |
Voltage | - Monitors for CPU Cores, +1.1V, +1.5V, +3.3V, +5V, +12V, +3.3V Standby, +5V Standby, VBAT, Memory Voltages.
- 6+1 Phase-switching voltage regulator
|
FAN | - 8x 4-pin fan headers (up to 8 fans)
- 8x fans with tachometer monitoring
- Status monitor for speed control
- Pulse Width Modulated (PWM) fan connectors
|
Temperature | - Monitoring for CPU and chassis environment
- CPU thermal trip support
- Thermal Control for 8x Fan Connectors
- Thermal Monitor 2 (TM2) support
- PECI
|
LED | - CPU / System Overheat LED
- Suspend static indicator LED
|
Other Features | - Chassis intrusion detection
- Chassis intrusion header
- RoHS, Halogen Free
|
|
![](https://www.supermicro.com/a_images/pixel.gif) |
Operating Environment |
![](https://www.supermicro.com/a_images/boxes/line_yellow.gif) |
Operating Temperature Range | - 10°C - 35°C (50°F - 95°F)
|
Non-Operating Temperature Range | - -40°C - 70°C (-40°F - 158°F)
|
Operating Relative Humidity Range | - 8% - 90% (non-condensing)
|
Non-Operating Relative Humidity Range | - 5% - 95% (non-condensing)
|