Gas Gas EC 200 2001 Sintered Motorcycle Front Brake Pads

Sintered Front Motorcycle Brake Pads

To fit Gas Gas EC 200 2001

1 set/s required

Compound

Metal-ceramic, typical iron friction material designed for both dry and wet friction. Finer additives compared with K1 material are added to the base iron compound. Lead and asbestos free.

Features

  • High static friction coefficient
  • Good abrasive resistance
  • High braking power to 500¡C
  • Very good binding strength between copper lined steel base plate and friction layer
  • Wearing rate 20% lower comparing with competitive sintered products of its category for common use
  • Low abrasive interaction with the brake rotor material
  • Three times +/- longer operational life compared to organic and Kevlar composite Materials

Suitable for

  • Dry and wet conditions for road/and off-road motorcycles
  • Road motorcycle application suited both for front/and rear
  • Designed for everyday road riding

Operating Parameters

Specific pressure: P < 5.0 Mpa
Sliding speed: V < 40 m.s-1
Constant maximum temp.: 450¡C
Short time maximum temp.: 700¡C

Notes

Replacement of brake pads should be done in dry clean conditions. If the friction material Comes into contact with oil or brake fluid and the liquid soaks into the pores of the friction Material, a catastrophic fall in friction coefficient (braking performance) could occur. Braking performance is significantly influenced by the quality of the braking surface of the Disc rotor, by the age and quality of the brake fluid, and by the correct choice of Complementary friction pad material.


580886#195712
Powered by
Multi Channel Software By Volo Commerce