678300 Cube Litening Super HPC Race carbon´n´green 

-----------------------------------------------

FITTING NOTES:

** Rear Derailleur Hangers should be fitted by a Qualified Cycle Mechanic and only after the original fault that caused any original hanger to fail has been diagnosed and remedied.

Hangers are sacrificial parts designed to break when the frame and / or drive train are under undue stress, thus reducing / eliminating damage to the frame and drive train components.

FAILURE TO REMEDY FAULTS BEFORE REFITTING A HANGER WILL RESULT IN THE NEW HANGER PERFORMING ITS DUTY AND BREAKING.**

-------------------------------------------------

PLEASE REMOVE YOUR HANGER AND OFFER UP TO THE PHOTOS SHOWN AND CHECK BEFORE ORDERING THANKYOU. DONT FORGET A SPARE HANGER TOO!

IF YOUR HANGER DOESN'T APPEAR IN THIS LISTING PLEASE REVIEW OUR OTHER HANGER LISTINGS, OR MESSAGE US WITH A PHOTO AND WE WILL GLADLY ATTEMPT TO MATCH AND PRICE IT FOR YOU BY RETURN.

TECH TIP:

Dont forget to carry a spare hanger on your bike and the tools to deal with it!

TECH INFO:

The derailleur hanger / mech hanger is the part of the dropout that the rear derailleur attaches to.

Most non-steel framed bikes have a separate removable derailleur hanger, generally made from aluminium which is bolted to the dropout. These are intended as a cheap replaceable part so that in the event of an accident or mechanical problem that could damage the derailleur or frame, the derailleur hanger breaks or deforms instead. Sometimes a shear bolt which is designed as a weak point will also be used. There are dozens of different derailleur hangers available and one model is seldom interchangeable with another.

In general, steel-framed bikes do not have a removable derailleur hanger, because a steel dropout and hanger is stronger and therefore less likely to be damaged, and also it is more malleable and less likely to work harden during deformation and generally can be bent back into shape without breaking.

It is important for proper indexed shifting for the derailleur hanger to be properly aligned. The rear derailleur bolt hole must be close to parallel with the rear axle. If it is out of alignment, the rear derailleur will not move far enough, with respect to the rear sprockets, with each click. A special tool exists to measure and correct misaligned hangers, referred to as A DAG - Derailluer Alignement Gauge.

-------------------------------------------------------------------------------

 BUYERS OUTSIDE OF THE UNITED KINGDOM – IMPORTANT NOTICE

Buyers may pay import charges (including tax and customs fees) when purchasing items from another country. Import charges are generally based on the item's price, postage weight, dimensions, country of origin, and taxes, duties, and fees of the destination country.

Buyers should make their own enquiries and satisfy themselves as to the extent of any applicable charges before purchasing. Buyers should also determine any of the intended destination country’s import regulations.

----------------------------------------------------------------------------------