EPEVER Tracer 3210AN Solar Charge Controller + MT50 Remote Meter

Description:

EPever Tracer series controller adopts MPPT technology (Maximum Power Point Tracking). This advanced tracking algorithm makes the solar module operate at an ideal voltage where the solar modules can produce the maximum available power. Compared to conventional PWM controllers, MPPT technology increases the charge efficiency by up to 30% and decreases the power of solar array needed.

The regulator has the ability to step-down the higher voltage solar array to recharge a lower voltage battery bank. This allows on grid solar modules or thin film modules to charge the off-grid battery, and the cable size can be reduced because of the small current from the solar array.

NOTE: If you are planning on using lithium-ion batteries it is necessary to select the correct battery type. Suitable pc link Cables and remote metres are available in our store.

FEATURES:

●Advanced MPPT technology, with efficiency no less than 99.5%

●Ultra-fast tracking speed and tracking efficiency

●Advanced MPPT control algorithm to minimise the maximum power point loss rate and loss time

●Wide MPP operating voltage range

●High quality components, perfecting system performance, with maximum conversion efficiency of 98%

●Accurate recognition and tracking of multiple-peaks maximum power point 

●Internationally famous brands of ST and IR's components of high quality and low failure rate are used, which

 can ensure the product’s service life

●Charging power and current limitation function

●Compatible with lead-acid and lithium-ion batteries

●Battery temperature compensation function

●Real-time energy statistics function

●Overheating power reduction function

●Multiple load work modes

●The communication port adopts professional protection chip which can provide 5VDC power supply, and

 has over-current and short-circuit protection. 

●With RS-485 communication bus interface and Modbus communication protocol. It is able to meet

 various communication requirements in different situations.

●Full-load operation without any drop in capacity within the range of working environment temperature 

●Extensive electronic protection 

 

SPECIFICATIONS

Battery and Load Wire Size The battery and load wire size must conform to the rated current. Reference sizes below: Model Rated charge current Rated discharge current Battery wire size Load wire size Tracer1210AN 10A 10A 4mm2/12AWG 4mm2/12AWG Tracer2210AN 20A 20A 6mm2/10AWG 6mm2/10AWG Tracer3210AN 30A 30A 10mm2/8AWG 10mm2/8AWG Tracer4210AN 40A 40A 16mm2/6AWG 16mm2/6AWG

Technical Specifications

Electrical Parameters   Item Tracer1210AN Tracer2210AN Tracer3210AN Tracer4210AN System nominal voltage 12/24VDC① Auto Rated charge current 10A 20A 30A 40A Rated discharge current 10A 20A 30A 40A Battery voltage range 8～32V Max. PV open circuit voltage 100V②                92V③ MPP voltage range (Battery voltage +2V)～72V Max. PV input power 130W/12V 260W/24V 260W/12V 520W/24V 390W/12V 780W/24V 520W/12V 1040W/24V Self-consumption ≤12mA Discharge circuit voltage drop ≤0.23V Temperature compensate coefficient④ -3mV/℃/2V (Default) Grounding Common negative RS485 interface 5VDC/100mA LCD backlight time 60S (Default) ①When a lead-acid battery is used, the controller doesn't have the low temperature protection.  ②At minimum operating environment temperature ③At 25℃ environment temperature ④When a lithium-ion battery is used the system voltage can’t be identified automatically. Environmental Parameters Working environment temperature -25℃～+50℃(100% input and output) Storage temperature range -20℃～+70℃ Relative humidity ≤95%, N.C. Enclosure IP30 ◆When the internal temperature is 81℃, power reduced charging mode is turned on. Refer to P24.  Mechanical Parameters Item Tracer1210AN Tracer2210AN Tracer3210AN Tracer4210AN Dimension 172x139 x 44mm 220x154x 52mm 228x164x55mm 252x180x63mm Mounting dimension 130x130mm 170x145mm 170x164mm 210x171mm Mounting hole size Φ5mm Terminal 12AWG(4mm2) 6AWG(16mm2) 6AWG(16mm2) 6AWG(16mm2) Recommended cable 12AWG(4mm2) 10AWG(6mm2) 8AWG(10mm2) 6AWG(16mm2) Weight 0.57kg 0.94kg 1.26kg 1.65kg Battery type   Lead-acid battery Lithium battery 1 Sealed(default) LiFePO4(4s/12V; 8s/24V) 2 Gel Li(NiCoMn)O2 (3s/12V; 6s/24V) 3 Flooded User(9～34V) 4 User(9～17V/12V; 18～34V/24V)

 

MT50 Features: 

• Automatically identifies the solar controller and displays the type, model and relevant parameter data.
• Large-screen multi-function LCD displays all the relevant data and system working status in digital format, graphic and text form. 
• With six navigation function keys the user operation is direct, convenient and quick.
• Real-time energy statistics recording
• Both way data flow on the same lead and no need for external power source 
• Real-time monitoring and acoustic alarm of failure information through the controller
• Longer communication distance based on RS485
• More powerful function Via MT50
• Diversified load control modes: manual, light ON/OFF, Light ON+Timer, Time Control 
• Battery type selection: Gel, sealed, flooded, Lithium and USER type
• Real-time monitoring
• Programmable parameters 
• Energy display function

Specifications : 

MT50 power consumption: Backlight and acoustic alarm on <65mA

                                     Backlight on <23mA

                                      Backlight off <15mA

Faceplate dimensions : 98×98 mm / 3.86×3.86 in

Frame dimensions :  114×114 mm / 4.49×4.49 in

Meter cable :  Standard 2m

Ambient Temperature :    -20°c~+70°c/-4°F~158°F

Package list:

1x EPever 3210AN 30A MPPT Solar Controller 

1x MT50 Remote Display

1x cable

1x Mounting frame

1x Instructions

Screws