This is our updated design of the 4" Fan duct for Antminers 120mm Fan.
Made with premium material manufactured in the USA.
The fan ducts take approximately 2 hours to print and are printed using the standard setting, not high speed. Each fan duct weighs approximately 73 grams each.
Don't be fooled, not all 3D material is the same.
Fan Ducts:
Best offer for quantity discount….
If you want/need these printed in a
different color or material, please message us for a quote. (this may
add time to manufacture)
Design may vary slightly from photo, but changes will only be cosmetic!
Please
Note - this listing is for the black adapter ONLY, this listing does
not include anything else ( flexible ducting or hose clamp or iphone)
Before you purchase, please verify the heat requirements that you need.
The 3 materials I use are listed below with the temperatures the material will start to go soft (Glass Transition Temp)
PLA Pro (PLA +) - 54C = 130F
HIPS – 80C = 176F
Polycarbonate (PC) - 112C = 233F
I am not responsible for the material going soft above the GT Temp.
There are many reasons a miner can run hot, ducting, bends/kinks, length of the run, air pressure to name a couple.