This is our Best Seller!
Ultimate Bearing Kit for Dillon XL650 or XL750 for eliminating the spills of powder when the shellplate indexes. Run out is minimized resulting in more consistent overall length of your ammo. This kit will make the operation of your press as smooth as silk.
Please watch the video in this listing. It contains the setup and adjustment information for your kit. The video covers installation for all variations of our kit, some chapters may not apply to the kit purchased. Instructions are not supplied with the kit.
This kit includes our metal ejector. It's no longer necessary to modify or tune the wire ejector. Our metal ejector eliminates all of the problems inherent with the wire ejector, such as case binding. This is a heavy cast part, just like several OEM parts from Dillon.
Re-adjustment of dies is not necessary.
3 powder measure adjustment knobs are included. These work with both new and old style powder measures.
Our Camming Pin Bearing reduces friction and smooths the reciprocating action of the case insert slide and slide cam. The same pin diameter as OEM allows the casefeed arm to function correctly. The hex cut into the end helps you properly align the bearing using an allen wrench. Our camming pins have a blued finish. We match the dimensions of the OEM pin. Our pin fully supports the casefeed arm, reducing vibrations and unnecessary wear. Reduced vibrations helps to keep cases correct side up when using a casefeeder. This is an exclusive feature of our pin. We make these pins in our shop using tool steel.
Our kits were featured in the Nov/Dec 2011 issue of Front Sight magazine.
How the low mass detent ball works:
This kit includes our Low Mass Detent Ball for the Dillon XL 650, XL 750, and is tough as nails. The LMDB and reduced power spring is custom made to our specifications, these are not off the shelf items. This ball is super hard, smooth and lightweight. It's approximately 7 times lighter than the factory steel ball and every bit as tough. The low mass detent ball and reduced power spring has less momentum when it locks up with the shellplate. The material also absorbs vibrations much better than the steel ball. This detent ball is highly abrasion resistant and will not be cut or scarred by the shellplate. These are industrial grade and used when strength and abrasion resistance is required.
This kit is our best solution for your 650 / 750 press, click here to see our eBay Store and all Shellplate Bearing Kits. Kits are available for RL 550, XL 650, XL 750, Super 1050, and RL 1100.
All of our kits and components are made in the U.S.A.