Sold since 2018, Updated design to make access to the middle screws easier, you should still be able to use the original screws.
!!!If you do purchase longer screws, please be advised manufacturers of ASIC miners have been known to place components behind the screw holes. So adding longer may damage those components!!! If you need to, add washers to reduce the chance of damage to components.
Our design have our initials on them ALWAYS!
Don't be fooled, not all 3D material is the same.
Fan Ducts:
Best offer for quantity discount….
If you want/need these printed in a different color or material, please message us for a quote. (this may add time to manufacture)
After Testing, we can not offer a 4" version, due to it limiting the air flow too much causing over heating on the miner. We do offer a 5" version as well as a 6" version.
Design may vary slightly from photo, but changes will only be cosmetic!
Please Note that USPS charges are much higher than FedEx for larger quantity orders, will always offer a choice, but FedEx will always be much cheaper than USPS for any larger packages!
Before you purchase, please verify the heat requirements that you need.
The 3 materials I use are listed below with the temperatures the material will start to go soft (Glass Transition Temp)
PLA Pro (PLA +) - 54C = 130F
HIPS – 80C = 176F
Polycarbonate (PC) - 112C = 233F
I am not responsible for the material going soft above the GT Temp.
There are many reasons a miner can run hot, ducting, bends/kinks, length of the run, air pressure to name a couple.