AT-OC9XEB Moving Coil Cartridge
This is the brand new Audio Technica AT-OC9XEB Elliptical MC Cartridge which replaces the trusty AT-F2 Moving Coil which is still available at £169 for a short while: See https://www.ebay.co.uk/itm/234057649566 for the last available examples of the F2
For those who want the latest incarnation of the cartridge, it is now available as the lowest rung on the OC9X ladder with similar cartridges available with Elliptical Nude, Microline and Special Line Contact Styli. If you have any queries about this cartridge, or choosing between them, just ask us a question and we'll be happy to help.
The AT-OC9XEB Dual Moving Coil cartridge with bonded
elliptical stylus is designed to provide outstanding channel separation. The
Pure Copper by Ohno Continuous Casting (PCOCC) coils ensure pure audio
transmission and are aligned in a reverse V-shaped formation to exert less
pressure on the stylus, thereby minimizing distortion. Audio quality is further
enhanced by a rigid aluminium body that reduces resonance, a neodymium magnet
and pure iron yoke that increase the magnetic energy, and the bonded elliptical
stylus on an aluminium cantilever that accurately tracks the record groove. The
cartridge body has been pre-threaded, enabling it to be mounted to a headshell
or integral tonearm with just two screws – no nuts required.
• Dual
moving coil design, featuring independent coils for both left and right
channels, provides outstanding channel separation
• The coils
are aligned in a reverse V-shaped formation, which exerts less pressure on the
stylus, thereby minimizing distortion
• The
cartridge body is pre-threaded, enabling it to be mounted onto the headshell or
integral tonearm with just two screws – no nuts required
• Features
a bonded elliptical stylus and aluminium cantilever
• A
neodymium magnet and pure iron yoke provide increased magnetic energy
• Aluminium
body minimizes unwanted vibration for reduced resonance and superior audio
reproduction
• Pure
copper by Ohno Continuous Casting process (PCOCC) is used for the coils to
achieve pure signal transfer
Specification
Type: Dual
Moving Coil
Body Material: Aluminium
Frequency Response: 20-30,000
Hz
Channel Separation: 25
dB (1 kHz)
Vertical Tracking Angle: 20°
Vertical Tracking Force: 1.8-2.2
g (2.0 g standard)
Recommended Load Impedance: Min.
100 ohms (when head amplifier is connected)
Coil Impedance: 12
ohms (1 kHz)
DC Resistance: 12
ohms
Coil Inductance: 25
mH (1 kHz)
Output: 0.32
mV (at 1 kHz, 5 cm/sec)
Channel Balance: 1.5
dB (1 kHz)
Stylus Shape: Elliptical
bonded
Stylus Type: Bonded
round shank
Stylus Curvature Radius: 0.3
x 0.7 mil
Cantilever: Aluminium
pipe
Static Compliance: 20
x 10-6 cm/dyne
Dynamic Compliance: 9
x 10-6 cm/dyne (100 Hz)
Wire Used for Coil: PCOCC
Terminal Pins: Brass
Mount: Half-inch
Weight: 7.6
g (0.3 oz)
Dimensions: 17.3
mm (0.68") H × 16.8 mm (0.66") W × 25.7 mm (1.01") D
Accessories Included: Non-magnetic
screwdriver; 2 washers; cartridge installation screws (5 mm × 2, 8 mm × 2, 10
mm x 2, 12 mm x 2); plastic protector; brush