Made with premium material
manufactured in the USA.
This is our own updated design of the 6" Fan duct for Antminers 140mm Fan.
The fan ducts take approximately 3
hours to print and are printed using the standard setting, not high speed. Each
fan duct weighs approximately 109 grams each.
Fan Ducts:
- · Protect your miners from heat. The original destroyer of
electronic.
- · Uses original screws. Easy fit, if you do purchase different
screws, make sure to be careful of the length. Antminers have capacitors behind
some of the screw locations, if too long you can blow the hashboard.
- · The fan ducts help reduce noise, and enable you to vent heat
away from miners.
- · Its printed using PLA so no risk of fumes, like you can with
ABS and heat.
- · Printed in Black just to make life easy for all.
- · Handling time may vary depending on how many we have printed
and how many you order. We will try to ship same day if quantities allow.
Best offer for quantity discount….
If you want/need these printed in a
different color or material, please message us for a quote. (this may
add time to manufacture)
Design may vary slightly from photo, but changes will only be cosmetic!
Please
Note - this listing is for the black adapter ONLY, this listing does
not include anything else ( flexible ducting or hose clamp or iphone)
Before you purchase, please verify the heat requirements
that you need.
The 3 materials I use are listed below with the temperatures
the material will start to go soft (Glass Transition Temp)
PLA Pro (PLA +) - 54C = 130F
HIPS – 80C = 176F
Polycarbonate (PC) - 112C = 233F
I am not responsible for the material going soft above the
GT Temp.
There are many reasons a miner can run hot, ducting,
bends/kinks, length of the run, air pressure to name a couple.