Custom Souvenir Coin Mint Set with Coin Dies.

— A coin or a medal can be two sides branded at the same time.

HOW TO ORDER:

— You can choose a diameter for coin's logos (from 10 millimeters to 32 millimeters).

— You can also choose (optional) a set of metal blanks for the minting tool: brass, copper or aluminum.

— You should send high-resolution black and white logo in JPEG, PNG or a VECTOR file in PDF format via eBay messages after purchasing.

— Black areas of your logo will be RAISED on the MINTED COINS.

— Lines of a logo must not be less than 0.25 millimeter in thickness.

— ONE INCH = 25.4 mm

HOW TO USE:

A) By using a hydraulic press (50–120 tons).

B) Hand-minting:

1. Find a wooden stump made of especially hard wood (e.g. oak) with a diameter of 40-50 cm and a height of at least 50 cm. In addition, you should have a hammer weighing 6-8 kg.

2. Mark the positions of the four tool holes on a stump.

3. Drill four 5 mm holes.

4. Fasten the minting tool on the stump using four self-tapping screws.

5. Put the bottom stamp (die), a coin blank and the upper stamp to the minting tool. Rotate the minting stamps so the obverse of a coin coincides with the reverse of the coin.

6. Make a sharp strong blow with a hammer exactly in the middle of the minting tool top. A quality of coinage depends on the strength of an impact and an accuracy of hitting.

7. To get better minting results, you can make several hammer blows.

In this case, it is necessary to control the position of the coin blank relative to the bottom and the upper stamps each time.

A coin blank should be in an engagement with the stamps, in other words the imprinted logo on a coin blank should be in recesses of the stamps.

8. Coin blanks are increased in diameter after minting, and they may be stuck in the guide ring. To remove a coin, you should strike with a small hammer using an opposite side of any stamp.

SPECIFICATIONS:

— The minting tool is hardened.

— The height of the tool with a lid is 11.95 centimeters.

— That is a high-quality product made in Europe (stamps have high-resolution, high-quality and precision of lines).

The minting tool consists of:

• Universal frame (anvil) for stamps mounting.

• One set of individual (custom logo) stamps (2 pieces).