Custom orange matte vinyl lettering that fits on STIHL chainsaws, blowers, weed eaters......back windows.  I make these and measure approx size is 3/4" x 2-1/2". Looks good on hardhats ......ect.

Easy to apply, just make sure the cover is ABSOLUTELY clean (alcohol) and ready for the vinyl. Tape the bottom down and flip it over to peel the wax / plastic coated backing. I use a credit card or bondo squeegee to apply, works good ..... Sometimes the lettering sticks to the backing. Just be patient and make sure it comes apart onto the transfer tape first. Then lay it on the background that you want. Here's some more updated info....

I do a lot of vinyl work and found that what buys you a few seconds in placement is soapy water, just a bit of soap. The solution dissipates and the decal sticks. You can move it around a bit for those few seconds. Then squeegee it down. Wait a minute or so before peeling the front transfer tape off. Make sure though that the cover is absolutely clean before all this. 

Made these with the horizontal alignment line that you peel off afterwards (if you want, it looks good with it). 

Again I personally make these so if you have any questions I will answer. 

I'll ship these out in a standard stamped envelope unless you want like 20 or so (there isn't any tracking that would cost you another $2.66).

THANKS

JAMES