Hello Kitty Face Bow Car Truck Wall Vinyl Window Decal Sticker, Iridescent Blue. Condition is "New".
**The vinyl shifts between many colors such as blue, green, purple, yellow, and silver tones depending on the angle and lighting!
features Shiny reflective green teal blue purple violet silver
Length x Width
Width is proportional to length (the smaller the size, the outline will proportionally be thinner)
Transfer tape to easily apply onto desired surfaces as well as application instructions
All vinyl sold is made from die-cut vinyl intended for use on any flat, dry, clean, non-textured surface.
Can be placed onto windows, vehicle windows, vehicle body exterior, laptops, cases
Application Instructions:
1. Thoroughly clean desired surface with an alcohol wipe or soap with water. Make sure it is dry afterwards.
2. Firmly rub the sticker with a scraper card or credit card to ensure the vinyl design's adherence to the transfer tape.
3. Peel transfer tape away from the backing and make sure the entire design is on the transfer tape. If a part of the design does not stick to the transfer tape, slowly replace the backing back onto the sticker and repeat step 2.
4. Apply the design with the transfer tape to desired surface in one section, then scrape the rest on with a scraper or credit card to prevent air bubbles.
5. Slowly peel the transfer tape away, pulling it back over itself. Should the vinyl not stick to the surface, scrape the transfer tape back onto the design, then repeat step 5.
Alternate Solution Instructions (for stubborn vinyl):
1. Thoroughly clean desired surface with an alcohol wipe or soap with water. Make sure it is dry afterwards.
2. On a flat surface, have the backing of the vinyl faced up and the design is faced down. Firmly rub the backing with a scraper card or credit card to ensure the vinyl design's adherence to the transfer tape.
3. Peel transfer tape away from the backing and make sure the entire design is on the transfer tape. If a part of the design does not stick to the transfer tape, slowly replace the backing back onto the sticker and repeat step 2.
4. Apply the design with the transfer tape to desired surface in one section, then scrape the rest on with a scraper or credit card to prevent air bubbles.
5. Slowly peel the transfer tape away, pulling it back over itself. Should the vinyl not stick to the surface, scrape the transfer tape back onto the design, then repeat step 5.