Display your LP’s, CDs or anything that you fancy with these 3D printed designed shelves

Choose from 8 colours (Black, white, red, yellow, orange, blue, pink & silver)

*PLEASE NOTE that £3.00 is for ONE shelf, discount is applied for multiple shelves purchased.

*Please leave a comment at checkout or send me a message as to which colour(s) you would like*

Can house single or double LPS

Strong and smooth design this will definitely compliment your vinyl

Width 80mm/8cm

x2 screws & rawlplugs included for a quick and easy fitting

As you can see from my examples I have showcased old, new single & double LPS so you can see how they look and fit.

The older gatefolds tend to stay closed (see my example photo of Goats Head Soup) where as the more recent gatefold designs don’t normally stay closed and try to open slightly, this isn’t a problem though as you can see by my Liam Gallagher photo - place a shelf at the top and bottom and you can slide your vinyl cover in from the side. (personally my favourite look)

If you have specific vinyl that you want to showcase then have a look (if it’s a gatefold) to see if it naturally stays closed or wants to open slightly, as this will help you when deciding on how you want the vinyl to appear on the wall and how many shelves you will need.

Printed to order and will dispatch within 5 working days (mon-fri), weekend orders will be sent out Mondays (bank holiday - Tuesdays)

Any questions then please ask

FITTING INSTRUCTIONS -

Place shelf where you would like to display your vinyl, hold a spirit level below, take a pencil and mark through the holes, drill 2 holes (unless you are attaching to wood), insert the rawlplugs, line up the shelf to the holes and screw in the plugs, check the level 1 last time before fully tightening the screws.

If using a shelf at the top as well then measure *32cm’s up from the base of the bottom shelf and mark this point, turn your top shelf upside down and use a spirit level, make sure it is not only level horizontally but vertically so it aligns perfect with your bottom shelf, mark your holes and repeat the process for attaching to the wall.

*I find that 32cm’s is a good fit for the sleeve to slide in from the side but it also allows a little room at the top once the sleeve is in position