Made with premium material manufactured in the USA.
This is our own updated design of the 6" Fan duct for Antminers 120mm Fan.
The fan ducts take approximately 2 hours to print and are printed using the standard setting, not high speed. Each fan duct weighs approximately 68 grams each.
Fan Ducts:
Best offer for quantity discount….
If you want/need these printed in a
different color or material, please message us for a quote. (this may
add time to manufacture)
Design may vary slightly from photo, but changes will only be cosmetic!
Please
Note - this listing is for the black adapter ONLY, this listing does
not include anything else ( flexible ducting or hose clamp or iphone)
Before you purchase, please verify the heat requirements that you need.
The 3 materials I use are listed below with the temperatures the material will start to go soft (Glass Transition Temp)
PLA Pro (PLA +) - 54C = 130F
HIPS – 80C = 176F
Polycarbonate (PC) - 112C = 233F
I am not responsible for the material going soft above the GT Temp.
There are many reasons a miner can run hot, ducting, bends/kinks, length of the run, air pressure to name a couple.