important!
Please note that with some cameras, closing the camera battery door is a necessary step to use the DC adapter kit. Please refer to our operation manual for the installation example of the dummy battery.
Advantage:
1. The Camera PD-BX Convertor can't only play the role of power adapter,It is different from most products on the market,The convertor With power status indicator and integrates 2 chips, one is used to identify PD and QC3.0/4.0 power, The other is used for 9V-24V wide voltage input, After the step-down treatment, the regulated output can effectively prevent high voltage, prevent high current, and prevent short-circuit, so it has multi-protection functions. If the dummy battery is connected, there are three important chips.
2. High-quality chips,DC-DC converter,high conversion efficiency,Good stability,quiescent current is small,while also serving to effectively suppress harmonic current noise.Using a wide range,suitable for most 7.2V-8.4V and 9V camera.
3. Compared with the ordinary USB Type-A (USB-A) power supply, the USB Type-C (USB-C) input PD power mode will get more power. Don't worry about the power bank will disconnect the power supply when the camera sleeps Output. If you use a Ordinary USB-A power supply,The camera will not be able to shoot at any time,  when the camera is in smart sleep mode or standby mode, the Power bank usually disconnects the power output after one minute, which will miss the snapshot.
4. Replace the camera battery handle grip or carry more batteries,camera insert battery grip  will too heavy,is not conducive to taking pictures.
PD tc8v tips
After connecting to the correct PD and QC3.0/4.0 power adapter or power bank, the red indicator light will always be on when the power is on. Certain models of cameras may consume higher current, so please use a high-performance power supply.
 
USB-C cable length:120CM
Input:PD 18W-65W

Output:9V USB-C Cable+DC Coupler kit with the following camera models: Compatible with: For Nikon1J1 For Nikon1J2 For Nikon1J3 For Nikon1S1 For Nikon 1AW1 For Nikon 1V3 and more models. Package Includes: 1 x USB-C Cable 1 x DC Coupler EP-5C 1 x Manual

VERY IMPORTANT: The power of the mobile phone PD charger must be between 18W -65W, The camera can start normally. Only support 18W 30W 45W 60W 65W PD Wall charger / PD mobile power supply / PD Car charger to power the camera, please do not use other devices, otherwise the camera will be damaged. This device is only used to power the camera, Do not connect other devices at the same time, Otherwise, it will cause insufficient power supply. Tips: General digital battery printed above parameters 7.2V / 7.4V labeled battery, it is the camera's minimum operating voltage, these batteries need to use 8.4V charger, full of power, charger 8.4V said no-load voltage, operating voltage and no-load voltage are two different concepts. External power used in the camera, You need to have enough power to supply, the camera is a load,the operating voltage is far lower than the no-load voltage.Therefore, the Camera adapter's no-load voltage is usually between 8V-9V (Note: the multimeter test is no-load voltage). Low input costs, Replace battery grip , suitable for indoor and outdoor.

Further top products See other items
由Supreme提供
supremeauctiononlinesoftware.staticWidgets.templateBased