For sale : A set of (two)  low profile FULLY ADJUSTABLE  vise stops made from aluminum 6061 and fitted with stainless hardware.

Stops are ONE INCH wide 

This stop can be used from the left or right hand side. 

Simply adjust the 1.25" (+)  long pin to the desired length on either side then tighten the 4-40 SET screws.   

THIS SET INCLUDES EVERYTHING YOU NEED ALONG WITH A FREE WRENCH FOR THE SET SCREWS AND ONE FOR THE STOP SCREW ITSELF !  

The pin is set BELOW the top of the vise jaw. ( ANY 1/8 PIN CAN WORK )

This lets you machine the edge of any part right down to the jaw.

These are very useful in any kind of set up where you do not want to hit the stop itself with your tool.

A wrench for both the pin adjustment, and the stop itself will be included with every purchase of one set.

 Stops will adjust to any standard vise jaw up to 1.05 inch thick.  

I just want to thank all of you that work so hard and choose to spend a few bucks here. I respect all of you.  

Please check out our other tools (in the last picture) including aluminum clamps.