Part Number GE7
Coil Spring Clamps can be used to either raise or lower the suspension on vehicles with coil springs. 1 Pack fits 1 Coil Spring so if you want to do 2 springs then you will need 2 packs
Lowering
Jack up the car underneath the suspension, taking the usual safety precautions. Remove wheel, position clamp approximately in centre of spring. Fit 'U' slot on top of the coil and insert bolts in holes of clamps. Position the other clamp with the 'U' slot under the next coil down, screw one nut on each bolt. Fit the other pair of clamps on the opposite side of the spring.Tighten nuts alternatively until the spring is sufficiently compressed, screw another nut on each bolt and lock in position.
Raising
Jack up car taking usual precautions, make sure weight is off spring to be fitted with clamps.Remove wheel, position clamp approximately in the centre of spring.Fit 'U' slots under coil and insert bolts in holes of clamp, screw two nuts on each bolt. Position the other clamp on the end of bolts with 'U' slots facing down. Fit the other pair of clamps on the opposite side of the spring. Screw up top nuts and lock under top clamp, adjust bottom nuts alternatively to the required height.Screw on the remaining nut and lock on bottom clamp, the bolts in these are 3" long
Please note the length of the bolts are 3" so if the gap in the coil is wider than that then the spring may have to be compressed first
Please make sure there is enough room around the coil over before fitting
More accessories in store
Mtec Racing Services
Please look at our other items