For alarms or operating relays not for switching pumps.

Extra long line float switch with stainless steel mount. Three mounting options: 

1.The float switch can be mounted to a Sump Pump Discharge Pipe with the supplied strap.

2. Clip mounted to a an edge up to 0.10" thick.

3. Through surface mount / tank top with a 10mm hole.

The kit includes 14 foot wire. float switch with sealed wire to switch connection allowing for switch submersion, stainless steel mount and two screws and a thick nylon tie strap for pipe mounting. 

The switch may actuate a pump relay, or indicator an alarm. It is rated for at 12 Volts DC at 12 watts. It can be easily converted from normally open contacts to normally closed by reversing the float on the switch shaft.

Max. Contact Rating: 12W Max. 
Switching Voltage:  12 Volts DC 
Max. Switching Current:   1.0A   Do not exceed switch contact ratings.
Temperature Rating:  -10 ~ +85 ℃ 
Float Ball Material:    PP   
Float Body Material:   PP+GF     
Screw Nut Material:  PP+GF  
E-Ring Material:  PP

Operate pumps through a relay. 

Use them with hydroponics, saltwater tank, Bait well, water tank, gardening pond, Hot water heater leak wells, aquariums, pet bowls, bait tanks, Boat lockers filtration, heating, pumps, ponds, basement alarms, boats, air condition, drain pans, pressure washers, carpet cleaning machines, fluid control, ice machines, coffee pots, marine,  evaporator coils condensation tanks, etc.