Double Wire Bolt Adjustment Clip

A very useful clip where concentrated clamping force is needed. 

All the clamp's capacity is focused on a fine contact area, and of course the smooth edges of the round wire will protect the hose when installation.

Product Details:

Material: H.T. wire zinc coated

Sizes:19mm-53mm

Easy to install.

Rounded Edges to protect wires/ pipes from damage.

Large room for adjustment.

Zinc coated for corrosion resistance.

    Quantities:

    Sold in boxes of

    40's

    Box Set Content

    Clamping Range Quantity
    19.0 - 23.0mm 10
    25.0 - 29.0mm 10
    30.5 - 35.0mm 10
    38.5 - 43.0mm 10

    Additions:

    Flexi Driver:

    The Flexi Driver is an indispensable tool for installing clamps, thanks to its long reach and flexible neck. Please refer to the link below for more information on the Flexi Driver.

    Flexi Driver Link

    How To Install:

    Slide Clip Over the item

    Make sure you have screwdriver or flexi driver

    Tighten the screw on the clip enough to hold the parts together 


    How To Decide on The Size:
    Always measure the outside (O.D) of the hose, not the internal diameter (I.D), then match the outside diameter of the hose to the inside diameter of the clamp. If the hose is 50mm outside diameter use a 46.5-53mm clamp.


    How To Remove:

    Get your screwdriver or flexi driver
    Undo the screw and remove the Clip
    A very useful clip where concentrated clamping force is needed.  All the clamp's capacity is focused on a fine contact area, and of course the smooth edges of the round wire will protect the hose when installation. Rounded Edges to protect wires/ pipes from damage. Zinc coated for corrosion resistance. The Flexi Driver is an indispensable tool for installing clamps, thanks to its long reach and flexible neck. Please refer to the link below for more information on the Flexi Driver. Make sure you have screwdriver or flexi driver Tighten the screw on the clip enough to hold the parts together  Always measure the outside (O.D) of the hose, not the internal diameter (I.D), then match the outside diameter of the hose to the inside diameter of the clamp. If the hose is 50mm outside diameter use a