Full set of multi colored halos to make your ride unlike all of your friends. Adds a unique look to this model of can am, makes them aggressive and angry ready to tear down a trail or bog through a mud hole.

Features

- 4 multi colored halos rings

-1 control box

-24function remote

-wiring diagram

-double sided 3M fitted tape

Fits :

-Can am Renegade 500, 570,650,800,850 & 1000cc 2007-current

-Can am Commander 800, 1000 2010-2020

-Can am Maverick 1000 2013-2019

This set has many options for your desire, multiple solid color options and has over 24 different modes to choose from strobe/fade/flash/and smooth fade as well as brightness adjustment

Halos are waterproof that have build in resistors for voltage change. These halos are not installed onto the actual headlight lenses but onto the headlight plastic bezel so no need to slit or open your headlights

INSTALLATION:

Step 1: Start with a clean surface. Get a degreaser and a glass cleaner use both to get best results. Clean around the headlight on the headlight bezel(plastic around lense)

Step 2: Drill a small hole at the top of the plastic bezel we're the halo will mount drill the hole just big enough for the connector to fit though.

Step 3: Prep the halo to get put on, stick the 3M tape onto the back of the halo evenly spaced and than feed the connector though the hole and set halo. Hold for 15-30seconds to get best result. (If 3M tape isn't desired for your instal you can use a RTV clear or black silicone to instal)

Step 4: Mounting the control box is key, closer to the exterior will give you better range and make sure it's close enough to plug all 4 halos into.

Step 5: plug all the connects in. There is arrows on each side of the connector they need to point at each other, Wiring of the control box is very simple. 12v Wire it either key on power or always on power directly from battery.

Red= positive

Black= negative