High current Ant 10s to 32s 300a li ion lifepo4 LTO smart bms with Bluetooth
Product introduction:

Discharging current: 120A(Peak 300A)
Charging current: 50A
Banlance current: 100MA
Wiring method: same port
Size: length 19.1CM width 7.6CM thickness 2.5CM
Single cell voltage: detection range 1V-4.6V, accuracy less than 5Mv
Overcharged and paid: protected
Short circuit protection: short circuit protection current can be set
APP connection: for Android
BT Mini Program connection:for Android & IOS
Applicable battery:
10S to -32S version:
10-32S Li-ion Battery; 10-32S Lifepo4 Battery;10-32S Titanium LTO lithium
Coulomb counter: accurate calculation based on current versus time
Battery remaining capacity, error range is less than 5%
Power consumption: 3MA at work
1.5MA during standby

Note: The cable is connected from the first black wire on the far right to the total negative electrode of the battery pack, which
is the negative electrode of the first cell of batteries.

Then start from the black wire and start from the first white wire from right to left to the first cell, second cell, third cell
of the battery and so on, and connect to the positive electrode of each cell in sequence. The minimum number of cells to be
connected is 8S, and the batteries of less than 32S are not left empty. After connecting, use a multi-meter to measure the voltage
on the plug row. There is no problem to confirm that the voltage is correct before plugging into the protection board The same
wire is connected to a red wire, regardless of its color), note that the last red wire on the third and last socket is B + which
supplies power to the protection board. It is connected to the cable of the last cell of batteries. That is to say, two wires need
to be connected to the bms on the last positive pole of the battery. There is a hole behind the last red wire of the third socket
and B + is redundant. You can leave it alone. Other instructions are the same as the 24S protection board