Ideal for effluent pumping applications.
Stainless steel and thermoplastic discharge and motor bracket are tough and non-corrosive. Both materials are highly resistant to damage by minerals, metals, and other substances typically found in water.
Heavy duty, 300 V, 10 ft SJOOW motor leads.
Ceramic bearing sleeve has time proven durability for years of reliable service.
Hex rubber bearing has extra large surface assuring shaft stability and multiple flow channels keeping particles away from bearing surfaces.
Proven hydraulic staging allows close tolerances and increased performance.
Carbon phenolic upthrust washer prevents excessive wear in severe applications.
Removable built in check valve on 10-20 gpm pumps. No built in check valves on high capacity pumps.
Powered by a ATER Pumps submersible motor.
Applications:
Filtered effluent service
Aeration
Ornamental fountains/waterfalls
You must change your bottom float when installing this pump an ATER WA-13-14-10 float switch is recommended
your warranty is void if this can not be proven the float must be a pump duty float switch