Silver-eMed C08 is complete end to end solution so you can make your own safe, micro-particle, therapeutic colloidal silver water (full kit & free shipping from London)
What is in the kit:
1. Silver e-Med c08
Colloidal Silver Generator
2. 2x10cm Ultra Pure Silver
Electrodes 9999 (99.99%) 1.5mm diameter
3. High quality micro USB
to USB cable (1m)
4. Portable Digital TDS
Meter 0-9990 PPM
5. Electrodes scouring pad
6. User Manual
Why you should consider our
solution and use it with confidence?
Fit for purpose: Our product is designed to produce the smallest particles in
size with range from 001 to .01 microns (10 to 100 angstroms) or (1 to 10
nano-meters). That is the size of silver particles that best absorb light in
the indigo range, leaving only its inverse color, transparent to yellow, to be
observed. It has a build-in step-up power module converting 5V to 27 volts and
current output limiting circuit to 1mA.
Fit for use: Powered by micro USB cable the kit comes
with portable Power Bank (18650 lithium-ion battery is NOT included in the kit). Due
to the device compact size you can always bring it anywhere with you and power
it from any USB port (computer, phone charger, etc.). Due to the current limiting circuit the silver electrodes lifespan is
significantly increased as well as the device extended operation on external
battery supply (over 24 hours with a single charge). Using the included digital
TDS meter you are able to precisely measure and reach the concentrations you
are targeting.
Why particle size matters? (Smaller is better)
An ion is much smaller particle compared to a colloid, and has different
characteristics. You can put trillions of ions in a drop of water
and it will remain perfectly clear.
Why we use LIMITED CURRENT and 27 VOLTS power output?
Any classical colloidal silver generator will produce ionic silver at the
same time it is producing colloids but the key difference to produce smaller
particles (ions) is limited output current to be applied. The emitted particle
size depends on the intensity of the electrical current while the concentration
(strength) depends on the time the current is flowing between the silver
electrodes. Higher currents tend to blast off larger particles from the silver.
Low (limited) current tends to generate smaller particles, and therefore
silver ions rich solutions. Following Dr. Bob Becker's recommendations and
our own extensive research in producing high quality colloidal silver water the
optimal direct current output appears to be within the range of 25-30
volts.
Silver-eMed c08 Technical specifications
Silver-eMed Batch Table
Hours (cycles) |
|
1h |
2h |
3h |
4h |
5h |
6h |
7h |
8h |
Color |
Transparent |
Transparent |
Transparent |
Transparent |
Transparent |
Transparent to yellow |
Transparent to yellow |
yellow |
yellow |
Strength (ppm) |
0 |
4 |
9 |
14 |
18 |
21 |
23 |
25 |
27 |
Current (mA) |
0.36 |
1 |
1 |
1 |
1 |
1 |
1 |
1 |
1 |
DC Voltage(V) |
27 |
27 |
27 |
27 |
27 |
27 |
27 |
27 |
27 |
When preparing your solution give it a time to reach the concentration you
are targeting. The batch cycles depends on the colloidal silver strength (ppm)
you desire to achieve. Electrodes will darken in color at the end of each
cycle. In order to produce high quality and pure colloidal/ionic silver water
we strongly recommend you carefully clean the electrodes before each cycle
(in one hour intervals).
Please, refer to the user
manual for detailed step by step process walk-trough.