This is a TrueBend metal brake line replacement kit. All lines are supplied double-flared at each end with S.A.E. specified male inverted flare fittings attached and are ready for quick and easy installation. All brake lines have an extra long nut on one end to seat in late model deep-seated wheel cylinders. These malleable lines are easy to bend or coil without collapsing the tubing or restricting the flow of brake fluid. Six couplers  and two special master cylinder nuts are included to join lines and attach parts. Instructions are also included.

Will not fit ABS units


this kit is for S10 Chevrolets and S15 GMC  two and four wheel drive, including Blazer for 1982 to 1998.

This kit contains all the lines to do a wide variety of S10 models, and many different configurations, so you will have unused lines in any installation. These extra lines are a bonus that can be used for other projects

The tubing is double walled, seamless and copper fused with a special inner and outer coating to provide protection from abrasion and corrosion. This is the same tubing that is used on new cars!

All information on lines are for OEM brake systems only. However, this kit has many lengths and will also service most modified systems also.

The lines attached to the master cylinder and brake block may be a non-standard size, and you may have to get an adapter at a local parts store.

If you need a very sharp bend next to the flare at the end of the line, you will need a bender listed under "tools/supplies" on our Ebay store.

All unions are solid brass to stop rust.

All lines are made in USA or Canada and are 3/16" or 1/4" outer diameter with a factory flare.

Fits following years: 90 1990 91 1991 92 1992 93 1993 94 1994 95 1995 96 1996 97 1997 98 1998