0.1-2000MHz RF Low Noise Amplifier DC 6-12V LNA RF Wideband Amplifier Radio Frequency Amplifier Module Broadband Module Receiver

Feature:
1. High Gain and Low Noise: This RF low noise amplifier boasts a wide frequency range, high gain, and low noise coefficient. It ensures optimal signal amplification while maintaining minimal interference or distortion.
2. Enhanced Communication Distance: With its application in various RF front-end receiver systems, this LNA module effectively increases communication distance. It enables reliable signal transmission over longer distances, enhancing overall communication capabilities.
3. Ideal for Different Applications: Whether it's for shortwave radios, FM radios, or remote control receivers, this RF signal power amplifier board is designed to deliver low-noise RF signal amplification. It is also suitable for applications such as cable TV signal amplifiers, where low-noise RF signal amplification is required.
4. Improved Signal Reception: By incorporating this broadband module receiver into your system, you can significantly improve signal reception quality. It enhances weak signals, allowing for clearer audio and stronger connections in RF-based devices.
5. Flexible Integration: Designed for easy integration, this radio frequency amplifier module can seamlessly fit into existing RF systems. Its compact size and versatile compatibility make it an ideal choice for upgrading and optimizing various communication setups.

 

Specification:
Certification: NONE
Origin: Mainland China
DIY Supplies: ELECTRICAL
Display Type: Analog Only
Model Number: RF Low Noise Amplifier
Dimensions: 50 x 25 x 5mm/2.0 x 1.0 x 0.2inch
Operating frequency: 0.1-2000MHz
Amplifier gain:
F=0.1MHz, gain=32dB
F=500Mhz, gain=31dB
F=1000MHz, gain=29dB
F=1500Mhz, gain=25dB
F=2000MHz, gain=20dB
Maximum output power: +10dBm (10mW) @ 1dB compression point
Noise figure: 1.9dB (see main view image)     
Supply voltage: 6-12VDC 
System impedance: 50 ohms
Tip:
1.Good gain flatness at operating frequencies less than 500 MHZ, which can be made less than 1dB with careful adjustment. the lower the frequency, the higher the gain consistency.
2.The lower limit of amplifier operating frequency is affected by the input and output capacitance, the default value is 0.1uF, operating up to 0.1MHz. increasing the input and output capacitance appropriately can extend the cut-off frequency, such as 10uF capacitance can work up to 5KHz.
3. When the supply voltage varies from 5-8V, it can be used as a variable gain amplifier, the gain increases with the supply voltage, it is suitable for RF receiving front-end circuit, using DA to control the supply power supply voltage, control the gain of the amplifier, automatic gain control.
4. When the supply voltage is 8-10V, the gain at the low frequency end can reach 30db, at this time the amplifier has a low noise factor and good stability.
5. When the voltage is 12V, the maximum gain is reached, and the gain at the low frequency end is 32.5dB.
Product features:
1. The product has a wide frequency range, high gain, low noise factor
2. The product can be applied to various RF receiving front ends to increase the communication distance
3. Used in short wave, FM radio, remote control receivers, such as cable TV signal amplifiers need low noise RF signal amplification

Note:
Due to the different monitor and light effect, the actual color of the item might be slightly different from the color showed on the pictures. Thank you!
Please allow 1-2cm measuring deviation due to manual measurement.

1 x RF Low Noise Amplifier