3D Printer Dual Fan Upgrade Cable Y Splitter JST-XH 2.54 2 Pin Male to Female

JST-XH 2.54 2-pin. 1x male to 2x female Y splitter parallel cable ideal for 3D printer fan upgrades or any other electronics. Increase your part cooling by adding a second fan without the need to splice or solder factory wiring. Another use is for adding a second battery for electronics. Wires are 26 AWG and approximately 18cm long.

Just plug the Y splitter male end into your controller board and female end into your fans (must be JST-XH 2.54 type connectors) and you're good to go!

This is also handy for Voron builders when combining the Raspberry Pi cooling fan and controller board cooling fan onto the same header on the controller board.

Important information

If you are purchasing new parts to use with this splitter cable, please review the wiring and specs to confirm this will work for you. Contact us if you have any questions. 

Condition: Brand New

Shipping - Free Australia-wide

 ~ ~ ~ Australian Stock for Quick Delivery ~ ~ ~

Item posts from Adelaide SA for FAST delivery via Australia Post.

This item is NOT drop-shipped from overseas so your item should arrive within days, not weeks.