Features:

* Application: Fit for Trim Caps on all SHOWA manufactured Trim/Tilt Units, All Suzuki, Honda, Johnson, Evinrude, ALL Yamaha I4 2.8L (F175-F200), ALL Yamaha VMAX, Yamaha F115-F150, Yamaha 2-Strokes (115-225hp)

* Feature: 1/2" socket drive - 46m-lb torque rating. 180 ft-lb min pin strength. Comes with 6 removable pins(4mm &4.5mm)
 

* Function: To rebuild a leaked device on outboard engine, hydraulic trim and tilt unit. Used to remove and install the Trim and Tilt Caps without damaging it and the steering cylinder.
 

* A Must Have: Usually, you will put a little drift into one of those holes in the trim and tilt caps with a hammer. Then, you destroy these cap, you will thrown them away, which cost a about hundred bucks. So, you really need the pin wrench to help you finish that case with ease.
 

* Material: Made of high hardened 4140 impact grade steel, with silver oxide coating which is rust-resistance and durable to use. Better than OEM.

Descriptions:

Outboard Trim/Tilt Pin Wrench - MT0006-32mm x 4mm (YB-06175-1A) 

-Used for removing Trim/Tilt Cylinder Caps compatible with ALL SHOWA manufactured Trim/Tilt Units.
-Equipped with 1/2" square drive for use with a torque wrench for proper installation. 
-Hardened Stainless Steel.

Works on: 

-Trim Caps compatible with ALL SHOWA manufactured Trim/Tilt Units 
-Trim Caps compatible with Yamaha F115-F150 
-Trim caps compatible with ALL Yamaha I4 2.8L (F175-F200) 
-Trim Caps compatible with Yamaha 2-Strokes (115-225hp) 
-Trim Caps compatible with ALL Yamaha VMAX 
-Trim Caps compatible with All Suzuki, Honda, Johnson, Evinrude

Function:

Rebuild the trim seal on the trim and tilt unit. Used to remove and install the trim caps without damage.

Yamaha Factory Tool: YB-06175-1A, YB-06548

-1/2" Socket Drive
-180 ft-lb MIN Pin Strength
-Same as Yamaha Factory Tool: 
-Replaceable Pins (AMT0005 - S-4mm)
-Fits Trim Seals on Yamaha, Suzuki, Johnson, Evinrude, Honda Outboards