Features:
* Application: Fit for Trim Caps on all SHOWA manufactured Trim/Tilt Units, All Suzuki, Honda, Johnson, Evinrude, ALL Yamaha I4 2.8L (F175-F200), ALL Yamaha VMAX, Yamaha F115-F150, Yamaha 2-Strokes (115-225hp)
* Feature: 1/2" socket drive - 46m-lb torque rating. 180 ft-lb min pin strength. Comes with 6 removable pins(4mm &4.5mm)
* Function: To rebuild a leaked device on outboard engine, hydraulic trim and tilt unit. Used to remove and install the Trim and Tilt Caps without damaging it and the steering cylinder.
* A Must Have: Usually, you will put a little drift into one of those holes in the trim and tilt caps with a hammer. Then, you destroy these cap, you will thrown them away, which cost a about hundred bucks. So, you really need the pin wrench to help you finish that case with ease.
* Material: Made of high hardened 4140 impact grade steel, with silver oxide coating which is rust-resistance and durable to use. Better than OEM.
Descriptions:
Outboard Trim/Tilt Pin Wrench - MT0006-32mm x 4mm (YB-06175-1A)
-Used for removing Trim/Tilt Cylinder Caps compatible with ALL SHOWA manufactured Trim/Tilt Units.
-Equipped with 1/2" square drive for use with a torque wrench for proper installation.
-Hardened Stainless Steel.
Works on:
-Trim Caps compatible with ALL SHOWA manufactured Trim/Tilt Units
-Trim Caps compatible with Yamaha F115-F150
-Trim caps compatible with ALL Yamaha I4 2.8L (F175-F200)
-Trim Caps compatible with Yamaha 2-Strokes (115-225hp)
-Trim Caps compatible with ALL Yamaha VMAX
-Trim Caps compatible with All Suzuki, Honda, Johnson, Evinrude
Function:
Rebuild the trim seal on the trim and tilt unit. Used to remove and install the trim caps without damage.
Yamaha Factory Tool: YB-06175-1A, YB-06548
-1/2" Socket Drive
-180 ft-lb MIN Pin Strength
-Same as Yamaha Factory Tool:
-Replaceable Pins (AMT0005 - S-4mm)
-Fits Trim Seals on Yamaha, Suzuki, Johnson, Evinrude, Honda Outboards