![](https://www.eusmile.com/kkimu1/images/kkimu1_spc.jpg)
- Condition: 100% new
- Color: Silver&Black
- Material: Metal&Plastic&Electronic Components
- Size: As picture shows
- Length of Wire: approx. 25 cm(9.8 inch)
- Maximum: 4000 W (resistive load connected)
- Voltage Regulation: AC 0-220 V, starts from AC 10 V
- Protection: anti-peak, surge, RC absorption (EOC)
- Item included:
1 x Motor Speed Regulator
1 x Control Panel
- Suitable for: electric furnace, water heaters, heating, lighting dimming, small motor speed, electric iron thermostat
-
This Is Aftermarket Replacement Item But Not Genuine
- Note:
1) All dimensions are measured by hand, there may be small deviations.
2) Color may vary slightly due to the color setting of each individual monitor.
3) Charge does not exceed the maximum power, otherwise it will burn the module and electrical appliances.
4) Use the resistive load as much as possible
- Reduce the capacitive and inductive load of much energy. (It is best to leave more than half of them).
![](https://www.eusmile.com/kkimu1/images/kkimu1_des.jpg)
Product Dimension:
Feature:
1) According to the original factory specifications.
2) Perfect match for the original one.
3) Easy installation.
4) Stable and durable.
5) The use of new two-way high- thyristor, because the current up to 40 amps, a good solution to the electric furnace wire in the case of cooling resistance is too small to cause over-current problems.
6) Can easily adjust the mains output voltage, at 0-100% (220 volts sub-100 level adjustment, non-linear) between the arbitrary adjustment for the use of electrical appliances.
7) In order to achieve dimming, tempe, regulating the effect.
8) Large electric appliances that can be used for electric less than 2000 watts Due to the large , the average home electric appliances or small factories are enough.(This regulator is equipped with two-way high- thyristor, can be used without any additional components, very convenient and practical). Comes with heat sink, the buyer can get the hand can be used.
How to Use:
1) The input is connected with the AC 220V.
2) Output wire is connected to the electric cooker or appliance motor.
3) Turn the knob for speed, voltage, temperature control.
![](https://www.eusmile.com/kkimu1/images/kkimu1_pic.jpg)
![](https://www.eusmile.com/kkimu1/images/kkimu1_home_hmain.jpg)