Fully assembled version of the RGB2HDMI for Amiga A600 for use with Amiga retro computers to enable an HDMI output.- BLUE PCB version.
You are purchasing a tested device (what is shown in the first photo), and we supply a micro SD card (4GB or 8GB) with the latest firmware on the card. The files for RGB2HDMI are only 25MB in size (tiny) so the smaller the card the better.
COMES WITH a SWITCH with short cable. This switch is not needed for operation, but is useful for accessing the MENU.
You will only need to supply a Raspberry Pi Zero with male header soldered. You can buy them at the links below when available. You can purchase the Pi Zero without header and solder one yourself of course.
https://thepihut.com/products/raspberry-pi-zero-wh-with-pre-soldered-header
or
https://shop.pimoroni.com/products/raspberry-pi-zero-w?variant=39458414297171
Plug the SD card into your Raspberry pi zero, plug it into the female header on the RGB2HDMI then place the PLCC socket upside down (line up correct corner) over the Super Denise chip (U4) on your motherboard. Be careful when pushing it on as its a tight fit, but needs to be so it does not pop off. Make sure it's FULLY pushed down else the connection won't power up the Raspberry Pi. If possible secure it in some way. You will need to be creative where you place the device and Raspberry Pi as in the example photos. We will not be responsible for damaged components due to lack of care.
Dispatched with Royal Mail 2nd Class, or via eBay GSP if outside the UK.
Please see this Github page for more info on this the RGB2HDMI project. https://github.com/hoglet67/RGBtoHDMI
Thanks for looking. See our feedback for peace of mind.