specification：

Spacer Thickness: 2"

Wheel bolt pattern: 6x5.5''                                        

Vehicle bolt pattern：6x5.5''

Thread Size：12*1.25                                                 

Hub Center: 108mm

Color：Silver                                                          

Number of Pieces: 4 PCS

 

Fitment：

For infiniti:
For infiniti QX4 1997-2003
For infiniti QX56 2004-2013

For nissan:
For nissan Armada 2005-2014
For nissan Frontier 1998-2004
For nissan Pathfinder 1987-2004
For nissan Pickup 1995-1997
For nissan Titan 2004-2014
For nissan Xterra 2000-2004

 

NOTE:  

Please make sure that these are the correct application for your vehicle. We do not guarantee any fitment onto any vehicle,we only guarantee that you will receive the item described as the above. Returns are only accepted if unused and not  installed.(ReturnsARE NOT ACCEPTED IF SPACERS-ADAPTERS HAVE BEEN INSTALLED TO YOUR VEHICLE) 

 

INSTALLATION TIPS

1.Please Make Sure You Take The Proper Measurements Before Purchasing.

2.Make Sure You Get 5-7 Turns Before Tightening.

3.Suggested To Be Torqued Down By Hand At 85 FT/LBS.

4.The Back Of The Adapter Must Sit Flush On The Hub.

 

What should I pay attention to during installation?

 

1) Check to make sure that the wheel spacer fits perfectly with the hub/axle stub and the inner mounting surface of the wheel.

2) Make sure that the wheel bolts being used are of the appropriate length, not too long or too short.

3) DO NOT proceed if both of the wheel spacer do not fit.

4) Please be sure to clean the rust on the hub before starting the installation, otherwise it will affect the working life of the spacers.

5) Make sure that you get 5-7 FULL TURNS of the lugs when installing. Torque them down to the manufacturers specs (up to and not greater than 110ft lbs).

6) Avoid using an impact wrench because improper usage may cause the lug nuts/bolts to break or loosen while driving causing a potential injury or accident.
7) All lug nuts, bolts and torque must be checked after driving the first 50 miles after installation. Afterwards, please check all lug nuts and bolts every 3,000-5,000 miles.

8) Alignment is necessary after installation, this will prevent any wobble and vibration from occurring.

 

How to measure the fender gap to choose suitable thickness?

1) Line up a straight edge ruler against the sidewall of the tire, use the measuring device to measure from the inside of the ruler to the inner fender lip.
2) Please take multiple measurements and use the smallest data point.(The most closest spot may be at the front or rear edge of the fender). The maximum recommended spacer
thickness= the smallest gap - 3/8"(10mm)