Power Supply Tester
ATX 20/24 - MOLEX - FLOPPY - Sata P4/6/8
Use :
For DESKTOP PC power supply. Standard Micro ATX or ATX whatever the power.
Allows you to test all power connectors: Floppy, Molex, Sata , ATX...
Compatibility:
Fully compatible with all power supplies.
Specifications:
Plastic Case
Test the cords:
ATX 20, ATX24, ATX 4P, ATX 6P, ATX 8P, Molex, Sata , Floppy
Test the following values:
+12V, +3.3V, +5V, -12V, +5VSB, -5V, and the PG value (response time in ms)
If the voltage is diffused, the corresponding LED turns green, likewise if the PG is between 100 and 900 ms
Operating Mode:
1- Turn on the power.
2- Connect the 20 or 24 pin power connector of the motherboard to the tester
3- The diodes correspond to the different voltages which are correctly emitted by your power supply: +5V, +12V, +3.3V, -5V, -12V, +5VSB.
4- Then connect your hard drive connector (molex): validate the +12V and +5V power supplies
5- Remove the hard drive cord, and now plug in connector P4 (6 or 8 connectors): validate the +12V power supply
6- Remove the P4 connector, and now test the Floppy connector: validate the +12V and +5V power supply
7- Remove the Floppy connector and now plug in the Sata connector: validate the power supply +12V, +5V, +3.3VCaution: do not leave the tester plugged into the power supply for more than a minute as this could cause it to overheat.
New item, sold in blister pack.
Warranty: 1 year.