Product Description
Solar Pond Water Pump Runs automatically, no battery or electricity needed, just the sunshine or Features a square solar panel to be staked on the ground. Solar Power Garden Water Pump Create a relaxing environment in your garden.
Product Specification
Solar panel: 9V/8W
Water pump output: DC 6-12V
Maximum flow: 200L/h
Maximum spray height: 70cm
Product Features
* 100% brand new and high quality.
* Solar powered, no extra power needed, energy-saving and environmentally friendly.
* Quick Start: Starts working in 3 seconds once exposed to sufficient sunlight. Please make sure the solar panel is not shadowed and keep the filter intake on the bottom clear of debris.
* Perfect for bird bath, fish tank, small pond, garden decoration, water circulation for oxygen.
1. Design: Water pump can float + filter function,All-copper motor, water level detection, Grid design anti-blocking, silent operation.
2. Solar Panel: the power of solar panel is upgraded to 8W polycrystalline laminated solar panel, which has a long service life and is not easy to be damaged.
3. Water Pump: with water shortage protection function, it can automatically cut off power when leaving the water to improve the service life of the product.
4. With LED Light: with 5 RGB LED light beads, White light+7 color transformations.
5.Remote Control: used for the opening and closing of the water pump and the adjustment of the three water levels. The remote control distance is about 15 meters, and the frequency is 433.92 MHz.
6. Function: The direct drive of the product works in the daytime, the light is off, and the power is stored for work at night. It can work for 4-7 hours at night under normal sunny conditions.
How To Use
1. Put the pump totally in the water with it is nozzle over the water, be sure the pump is fixed firmly on the bottom of the fountain to avoid vibration.
2. Plug the jack of pump in the jack of solar panel output.
3. Put the solar panel under enough sunlight and be better to face directly to sun.
Please Note
1. The height of the water cannot be adjusted, please ensure that the water source is clean, turbidity will also cause it to not work
2. There is a thin protective film on the surface of the solar panel. It must be torn off before it can work properly. If not, it has been torn off.
3. Connect the water pump to the solar panel, make sure the wiring is not loose.
Be sure to test run the pump before putting it in water to evacuate the air inside, and be sure to immerse the pump in water.
And you need to charge the solar panel for more than 8 hours under strong sunlight.
When there is insufficient sunlight, the project cannot continue to work.
It is recommended to connect the pump head after the water pump is normally sprayed.
4. Please check if the pump is stuck, if it is stuck, it will not turn, you can shake it to make sure it is not stuck.