This lot includes the following molds:

1 - Crafter’s Choice Euro Rectangle Silicone Mold 1613 - USED
Mold Capacity (oz): 72
Bar Cavities: 15
Avg. Bar Weight: 4.8 oz
Bar Length: 2.8
Bar Width: 1.8
Bar Depth: 1.5
Max Temperature: 500ºF

1 - Crafter’s Choice Oval Guest Silicone Mold 1608 – NEW
Mold Capacity (oz): 18
Bar Cavities: 9
Avg. Bar Weight: 2 oz
Bar Length: 3"
Bar Width: 1.75"
Bar Depth: 0.75"
Max Temperature: 500ºF

1 - Crafter’s Choice Tray 12 Rectangles Silicone Mold 1701 – USED
Mold Capacity (oz): 84
Bar Cavities: 1 Slab with 12 Rectangular indents
Avg. Bar Weight: 7 oz
Bar Length: 3.25"
Bar Width: 2.5"
Bar Depth: 1.25"
Max Temperature: 500ºF

Directions:

Melt & Pour Soap: Pour melted soap into silicone moldcavities. Allow soap to cool at room temperature until hard. Carefully removesoap from mold by gently pulling the sides away from the soap, and then push onthe bottom of the mold until the soap starts to release. Grab hold of the soapand carefully pull out of the mold.

Cold Process Soap: Pour soap at trace into the mold cavities.After at least 24 hours, gently pull silicone mold to loosen its grip on thesoap. Flip mold over onto a clean surface and gently push on the bottom of molduntil the soap starts to release. Grab hold of the soap with a gloved hand, andallow soap to cure for 4-8 weeks. Note that some cp soap recipes may require aweek to harden enough to remove from the mold. If this is the case with yourrecipe, we recommend adding sodium lactate to your recipe to assist withcreating a harder bar faster.

Cold Process/Oven Process Soap: Pour soap at trace into themold cavities. Preheat oven to 170ºF then place mold in oven. Turn oven off,and keep soap in oven overnight. The next day remove mold from oven. Carefullyremove soap from mold by gently pulling the sides away from the soap, and thenpush on the bottom of the mold until the soap starts to release. Grab hold ofthe soap and carefully pull out of the mold. Allow soap to cure for 2 to 4weeks.

Hot Process Soap: Scoop hot process soap into mold cavities.Gently tap the mold onto the counter to remove air pockets. Allow soap to cooland harden. (This can take up to 48 hours.) Carefully remove soap from mold bygently pulling the sides away from the soap, and then push on the bottom of themold until the soap starts to release. Grab hold of the soap and carefully pullout of the mold.

Lotion Bars: Pour melted lotion bar mixture into moldcavities. Allow mixture to solidify. Carefully remove lotion bars from mold bygently pulling the sides away from the lotion bars, and then push on the bottomof the mold until the lotion bars starts to release. Grab hold of lotion barand carefully pull out of mold.

Care:

Hand wash in warm sudsy water.