**********Tips For Use**********
*If making your own patch cables make sure to use the EIA/TIA-568B standard wiring pattern
*Make sure the wall plate labeled "HDMI In" is at the side with the source device, while the plate labeled "HDMI Out" is at the display side
*Make sure that the CAT5e/6 cables are plugged into the appropriate jack on the backs of each wall plate. The cable you plug into "port 1" on one plate needs to be the same cable you plug into "port 1" on the opposite plate. In order to distinguish which cable is plugged into which port, you may want use different color patch cables or simply mark the ends with a distinguishing feature such as colored electrical tape.
*Under many setups this extender will draw the necessary power from the HDMI cable itself, so that is why the power supply is optional. If you have signal issues, you may need to use the power supply in one or both of the wall plates to supply the necessary power to boost the signal. There is also the option to hardwire the 5V power supply into the back of the wall plate so that it is hidden.
*It is strongly recommended that any HDMI cables up to 15ft have at least 28 AWG conductors in them. Any HDMI cable over 25ft should have at least 24 AWG conductors. Beware that many sellers on the market sell the short HDMI cables with 30 and 32 AWG conductors that may work independentely, but are basically impossible to use in a setup with extenders.
*This extender will work with CAT5e cables, but we recommend using CAT6 cables where possible. Also, solid conductor cables carry a stronger signal than their stranded counterparts, so if possible use solid cable. Lastly, shielding isn't required in your patch cables, but if possible we suggest you use them. In conclusion, many cables can get the job done, but the best option is to use a CAT6 Shielded Cable with Solid Conductors especially if you are going to try and max out the distance.