BOX FENCE ENCLOSURE

(FOOTPLATE OR FIXED INTO THE GROUND)

 

 

Box measurements 200 x 100cm – occupies an area of 3sqm

 

Box heights

 102cm

122cm

142cm

172cm

192cm

 

Method of installation

 Fixed by footplate

or

Fixed into the ground

  

* Choose the height and method of installation from the drop-down menu located at the top, under the title of the product.

 

OFFER CONTENTS

(based on the height of the fence selected, all products of the composition will have the same height)

 

BOX FENCE WITH FOOTPLATE

 

1 Galvanized gate green PVC coated with welded mesh 50x50x4mm – frame 35/40mm – complete with side pillars and handle with lock and key.  

Measurements L100cm x selected height

 

2 welded PVC coated green panels

L200cm x selected height

 

1 welded PVC coated green panel

L100cm x selected height

  

2 round green tubular posts, diameter 48mm, complete with 3 brackets/collars for fixing the panels to the post

 

2 galvanized round footplates/supports for fixing the round posts

 

2 galvanized square footplates/supports for fixing the gate posts

 

Assembly instructions included, for an installation fast and simple.

 

OR

BOX FENCE TO BE FIXED INTO THE GROUND

1 Galvanized gate green PVC coated with welded mesh 50x50x4mm – frame 35/40mm- complete with side pillars and handle with lock and key.  Measurements L100cm x selected height.

 

2 welded PVC coated green panels

L200cm x selected height

 

1 welded PVC coated green panel

L100cm x selected height

 

2 round green tubular posts, diameter 48mm, complete with 3 brackets/collars for fixing the panels to the post.

 

Assembly instructions included, for an installation fast and simple.

 

Some photos

 

Footplate/support for fixing the gate’s posts and pillars

Product finishings:

Galvanized wire + phosphating with zinc salts and plastification with polyester.  The wire used to produce this mesh is continuously hot-dipped in a zinc bath to guarantee maximum resistance and durability to the product.  Subsequently after assembling the panel, the plastification process, which involves 7 stages, is applied and which ensures the best quality of the product.  The first phase involved is degreasing (1) to remove any residual surface oil, grease or dust.  Subsequently  a further washing (2) to remove any impurities and other residues of degreasing.  At this point the cycle of phosphating begins:  washing with demineralized water (3), and an application of zinc phosphate (4).  The product is then dried (5) in the oven at 120° in preparation for the next phase of plastification (6) with 100% pure polyester resins.  Through polymerization (7) the polyester layer is secured to the support.

N.B. IF YOU BUY MORE PRODUCTS FROM OUR E-BAY STORE 

YOU PAY A SINGLE SHIPPING FEE! TAKE ADVANTAGE !!!