Here is a complete set of Pintle caps, O-rings (upper and lower), Inlet screens, Spacers, and Retainer Clips for Bosch and Rochester Products fuel injectors used on 2.8L V6 engines with EV1 style injectors. Enough parts to service six (6) injectors.

The kit contains:
12 O-rings
6 Pintle caps
6 Inlet screens
6 Spacers
6 Retainer Clips
Total of 36 pieces.

NOTE: The injector pictured is for illustrative purposes only and is NOT included.

Note: The o-rings must be lubricated with light oil or petroleum jelly during installation. Failure to do so may result in damage to the o-rings.

Note: The Pintle Caps you will receive will be either Blue in color, Brown in color or Yellow in color depending on our inventory in stock at the time of the order. If you have a preference, you can mention it when you order and we will try to accommodate the request but not guaranteed as our inventory changes daily.

Note: Proper installation of the clips requires the receiver grooves in the injectors and the fuel rail to be clean. The clips must be carefully and correctly aligned with the receiver grooves in the fuel rail as they are installed and rotated. If they are not aligned, the clips can be damaged as they are rotated into the locked position by hand. Special tools are not needed to accomplish this. (Hammers are forbidden.) Rocking the injectors slightly from side to side as the clips are rotated may help with locking them in position. By purchasing these clips, the buyer acknowledges they have the skills to accomplish the installation correctly and will not hold the seller responsible or liable for any damages to the clips, the injectors or the fuel rail.
 
Terms & Conditions:
Free USPS shipping is based off of addresses located within the United States. This includes Puerto Rico, Alaska and Hawaii.

International shipping is handled by eBay's Global Shipping Program.

 


Please be sure this part is correct for your vehicle before purchasing. We provide the part number and a picture of the actual part. We do our best to list the applications the part will fit however we cannot be sure it is correct for your particular application.  That is Your responsibility.  All returns not due to a listing error on our part may be subject to a 15% handling fee. Returned items must be in original packaging and uninstalled condition. 



Installation of these parts by a Licensed Professional Mechanic is recommended. These parts and/or the injectors and/or the engine may be damaged if the parts are not installed correctly. If you don't have the knowledge and/or ability to correctly install the parts, take the injectors to someone that does. In no event will the seller be liable for any damages, direct or indirect, consequential or compensatory, including, without limitations, lost profits, for any representations, breaches or defaults arising out of the use of this part. By purchasing these parts, the buyer acknowledges they have the knowledge and ability to safely and correctly install these parts, and will not hold the seller liable for any damages or injury resulting from the installation of these parts.