- Condition: 100% new
- Light Colors: 7 Green & 2 Orange & 3 Red
- Material: Plastic & Chip
- Size: approx. 8x1.4 cm(3.14x0.55 inch) (LxW)
- Working Voltage: DC 7-12V 100mA
- Item included:
1 x dual 12 level indicator DIY kits
1 x 5pin cable
- Suitable for:adjust each light bar and the main peak of the real speed of light
-
This Is Aftermarket Replacement Item But Not Genuine
- Note:
1) All dimensions are measured by hand, there may be small deviations.
2) Color may vary slightly due to the color setting of each individual monitor.
3) When welding is completed for the first time test, the factory setting must be restored by pressing and holding the button for 10 seconds. Because the program burned into the chip is not in the initial working state, you must restore the factory settings first, then the level lights are in normal working condition!
4) The data will be saved automatically after 5 seconds in every setting is changed. when the data will be saved, all the lights will extinguished one time. due to the first restore factory settings will save multiple data, so the lights will extinguished many times, please wait for all the data stored and then power-off or other settings and operations! If the power is changed immediately after the change, the changed data will not be saved.
5) MCU used time-sharing sampling when sampling, so that there is dual-channel simultaneous parallel input signal changes fast, the amplitude of the two light bar display may may be differences, this is a normal situation.
6) In extreme cases, there maybe have very slight high frequency noise. Recommended to replace the signal input wire to dual-core shielded wire in head position.
7) Operating Voltage: 7-12V, Current can work in more than 100MA. Prohibited Voltage exceeds 12V or positive and negative reversed, otherwise it will cause level indicator damage.
Product Dimension:
Feature:
1) Follow the original factory specifications.
2) Ultra-small size stereo level lights, light bar can be adjusted to rise, the rate of decline and peak lamp residence time, the rate of decline.
3) Each lamp set up a separate current limiting resistor, ensure the same brightness of the different color lights, signal input through the op-amp isolation, avoid single-chip high frequency interference audio.
4) The feature-rich, user can freely adjust each light bar and the main peak of the real speed of light, with the most suitable for their own display.
5) Audio input through the TI original signal isolation, the maximum to avoid the single-chip high-frequency interference to an audio circuit in series.
6) Different colors of light alone provided a current limiting resistor. Guarantee a perfect match.
