- Condition: 100% new
- Color: Silver & Green & Yellow
- Material: Plastic & Alloy
- Spike Diameter: approx.6mm(0.2inch)
- Handle size: approx.10.3x3cm(4.1x1.2inch)(LxW)
- Sleeve size: approx.4.7x0.6cm(1.9x0.2inch)(LxID)
- Item included:
100 x Tire Stud Screw
1 x Sleeve Tool
- Compatible With: fit for most tire
This Is Aftermarket Replacement Item But Not Genuine
- Note:
1) All dimensions are measured by hand, there may be small deviations.
2)Please choose appropriate size of new studs in the installation process in terms of the depth of tire thread.
Product Dimension:
Feature:
1) These stud spikes bring a good anti-slip property for your tires. Add ultimate off-road capacity to your ordinary car, truck, motorcycles,etc.
2) Low ground pressure, environmentally with minimum impact.
3) Simple hand sleeve tool, to easily install and remove the anti-slip tire stud screws.
4) Suitable for 6 mm stud screws.
How to install the tyre studs?
1) Put the car tire studs into the sleeve tool.
2) Drill (using a very small bit) down from the center of chosen knob into the tire.
3) Drill a screw up from inside-out. If the angle isn't perpendicular to the tire, it'll stick out one side or the other.
Do one hole and screw at a time. Don't try drilling all the holes, then installing screw.
4) Put duct tape over the screws on the inside of the tire; sometimes it is best to use two layers of tape.
