- Condition: 100% new
- Body Color:White
- Light Color:Yellow/Blue
- Material: Anti-collision adhesive
- Size:approx.16.5x2.2cm (6.5x0.87inch) (L x W)
- Cable Length:approx.195cm(76.7inch)
- LED Amount: 9 (each light)
- Voltage: 12V DC
- Item included: 2 x LED Rear View Mirror Turn Light Lamp
- Compatible With:fit for all car
This Is Aftermarket Replacement Item But Not Genuine
- Note:
1) All dimensions are measured by hand, there may be small deviations.
2) Color may vary slightly due to the color setting of each individual monitor.
3)Instruction is not included.Professional Installation Is Highly Recommended!
Product Dimension:
Attribute:
Feature:
1) 100% new and good quality material.
2) Use soft circuit board & 3M tape, available for curve surface mirror.
3)Available to connect with small lamps or turn signal lamp.
4)Heatproof, waterproof and durable.
5)Thinnest type with high brightness LED.
Installation Notes:
Method (a): must be removed when the mirror
1) First bend this product into the same curvature as the mirror.
2) And then force paste up.
3) Remove the car tripod.
4) Loosen the screws and remove the mirror.
5) Thread the wire through the round hole of the tripod.
6) Use a double-sided adhesive to secure the wire under the mirror so that it is not easy to see the wires.
7) Use the gap to wire the engine room, connected to a small lamp.
8) Perfect installation.
Method (b): do not have to remove the mirror.
1) First bend this product into the same curvature as the mirror.
2) And then force paste up.
3) Use a double-sided adhesive to secure the wire under the mirror so that it is not easy to see the wires.
4) The wire is attached to the edge of the door along the mirror.
5) Use the gap to wire the engine room, connected to a small lamp.
6) The perfect installation.
7) The light can still be seen from the rear.
8) The perfect installation.
