Fitment:
for all most Cars
Specification:
Product name:Car Brake Light Strip
Bulb Color:Red
Size:90cm
Voltage: DC12V
Light Source:LED
Waterproof: IP68
Functions: Brake + Drive light+ Turn Signal+Double flash
Feature:
Waterproof and durable soft silicone body
High-brightness LED lamp bead brightness high and low light decay life long durable,Super Bright.
Intelligent decoder can be used directly by wiring, saving time,Lower power consumption ,bulit in fuse.
The wire ends are designed with pins, without breaking the original power supply for non-destructive installation.
Starting Mode: After Turning on the width light,8 seconds flashing, then Constantly bright.
Driving mode: Low brightness,Constantly bright.
Braking mode: One second flow, high lightings.
Wire Connection:
Red: Clearance Light
Black:Earth Wire, Power Negative
White:Brake Light
How to Install:
1.Please use detergent or alcohol to clean the surface of the target area before stick it on.
2.Use the hair dryer to heat the tape a little.
3.Stick it on and keep your car non-washed. within 48 hours to achieve the best adhesiveness.
4.Try to finish the steps one time,do not peel off from one area and stick on another area to avoid bad adhesiveness.
Package Included:
1x Rear Windshield LED Third High Brake Light Strip
Note:
1. Please kindly confirm the fitment before ordering to make sure this item is perfectly fit.Please measure your rear window size before you buy this product.
2. It is easy to install, but professional installation is always recommended.
3. Please allow 0.5-1 inch difference due to manual measurement.(1inch=2.54cm)
1.Item usually will be shipped within 24 hours after your full payment has been received.
1.Item usually will be shipped within 24 hours after your full payment has been received.