Vilros Raspberry Pi Pico With Header Complete Starter Kit
You can get started With PICO using the Get Started with Micro Python on Raspberry Pi Pico book.
The Book is book sold separately or can be downloaded for free.
Parts & Components
1 × Presoldered Raspberry Pi Pico with male headers attached
1 × Half Size Breadboard
- 400 Hole
- Sticky Back
1 x Battery Holder and Breadboard Panel
- Holds the Breadboard and Battery Holder in place for an easy and neat wiring experience.
30 × Jumper wires
- 10pcs male-to-female (M2F),
- 10pcs male-to-male (M2M)
- 10pcs female-to-female (F2F).
3 AA Battery Holder with Micro USB Connector
- Power the Pico on the GO
1x Neoprene Parts Storage Case with Pocket
- Internal Dimensions: 10x7 inches
- Double Zipper
- Black Neoprene
- Pocket for accessories storage
- Loop Handle
1 × USB Type-A to Micro Type-B 2.0 Cable
- 5-Pin
- 28/28AWG
1 × 3 Pin header.
- Can be used on the SWD Pads if desired. (The SWD pads are NOT used Get Started with Micro Python on Raspberry Pi Pico book and not used in most projects)
Raspberry Pi Pico Specs:
- 21 mm × 51 mm form factor
- RP2040 microcontroller chip designed by Raspberry Pi in the UK
- Dual-core Arm Cortex-M0+ processor, flexible clock running up to 133 MHz
- 264KB on-chip SRAM
- 2MB on-board QSPI Flash
- 26 multifunction GPIO pins, including 3 analogue inputs
- 2 × UART, 2 × SPI controllers, 2 × I2C controllers, 16 × PWM channels
- 1 × USB 1.1 controller and PHY, with host and device support
- 8 × Programmable I/O (PIO) state machines for custom peripheral support
- Supported input power 1.8–5.5V DC
- Operating temperature -20°C to +85°C
- Castellated module allows soldering direct to carrier boards
- Drag-and-drop programming using mass storage over USB
- Low-power sleep and dormant modes
- Accurate on-chip clock
- Temperature sensor
- Accelerated integer and floating-point libraries on-chip
Raspberry Pi Pico Pinout Guide Card
----------------------------------------------------------------------------------------------
