***PLEASE NOTE ODERS PLACED AFTER 1PM WILL BE SENT NEXT WORKING DAY

ORDERS PLACED BEFORE 1PM WILL BE SENT SAME WORKING DAY***

If you have a traditional  Points distributor and coil  ( or a converted points to aftermarket electronic ignition ),  this is all you need to install your own Flame kit , You don't need to spend £70.00 +  on fancy kits 

We have put together all the components you will need to fit a  simple but highly effective flame kit , you just need to add your own wire and terminals

 
Car show in Demo has our simple kit fitted . 
Comes with easy to follow instructions and can be fitted in under 1 hour 

Apart from a bit of wiring the only thing you need to do is drill a hole in the exhaust and weld the nut that holds the spark plug in end of exhaust .

Suitable Cars with Petrol engines and a traditional ignition single Ignition coil .

It is not suitable for cars with multiple  coils or coil packs or ECU controlled ignition ( please don't email us if suitable for your car, you must have a traditional points distributor and coil ) 

We put this kit together to work on our own show cars with traditional distributors and coils and we will provide simple instructions as to how to fit but please note we can't give information about specific cars or other set ups 

It works by diverting the signal going to the coil to a extra the coil at the back of car to spark the exhaust plug , 
You will note from the video that while the flame is on the engine is cut . 

Flame kits are for off Road and Show use only .

This item  can be seen working at link below 

https://www.youtube.com/watch?v=MJl87DoqQ_0