- Condition: 100% new
- Color: Black
- Material: Aluminum Alloy
- Size: approx. 16.5 x 3.8 cm(6.5 x 1.5 inch) (LxW)
- Placement on Vehicle: Exterior, Rear
- Item included: 1 x Third Brake Light Cover
- Compatible With: fit for Jeep Wrangler JK 2007-2017
-
This Is Aftermarket Replacement Item But Not Genuine
- Note:
1) All dimensions are measured by hand, there may be small deviations.
2) Color may vary slightly due to the color setting of each individual monitor.
Product Dimension:
Feature:
1) According to the original factory specifications.
2) Perfect match for the original one.
3) Easy installation.
4)Full polished aluminum alloy construction that helps stability and strength when mounted.
5) High quality powder coat that resists rust and dirt.
6) Help to protect Taillights while also providing an Off-Road Look.
7) Directly over your existing taillights allowing plenty of light to shine through. Give the rear vehicles eye-catching USA mark brake lights with when you touch the brake pedal.
Installation:
1) Pls use alcohol or agent to clean the position of the installation (to make sure it without the grease.Wax or dust etc).
2) Pls ensure the position of installation can be completely fit the case before install.
3) Rive the strong double-sided adhesive of the back, if meet the case of a relatively low temperature, please heating it via the hair dryer.
4) According to the comparison stick up it and press about 1-2 minutes (Note:do not wash your car in 24 hours, the adhesive should be fixed after 24 hours ).
5) The installation has been completed.
