3D Printed Plant Pot Raiser - Small & Large - Flatpack

A flatpack style plant pot raiser in 2 sizes. Each size uses the same style "foot" & each of the 4 feet will need screwing into the main body prior to use. 

Once assembled, the raiser creates a gap of 3cm from the ground, allowing plenty of space for water to drain.

No plant pot or plants included

-------------------------------------------------------------------------

Model Dimensions:

SMALL: L:105.0mm x W:105.0mm x H:15mm

(L: 10.5cm x W: 10.5cm x H: 1.5cm)

LARGE: L:182mm x W:182mm x H:15mm

(L: 18.2cm x W: 18.2cm x H: 1.5cm)

Foot: L:18mm x W:18mm x H:30.8mm

(L: 1.8cm x W: 1.8cm x H: 3.0cm)

Actual dimensions might be out by +-1mm.

Plastic Type: 

PLA

-------------------------------------------------------------------------

Most orders will be printed on the same day of order, but please allow up to 2 days before item is dispatched.

PLEASE NOTE: Whilst great care has been taken to remove any sharp edges, some might remain so please take care when handling. Printed parts are also very strong, but not indestructible.

Custom design by AllYour3D-Prints