Urethane Slot Car Tyres x 4 Wasp 21 20 x 14 x 3.6 x 7 SCX GT Large
Made from Hi definition 3D printed blanks for perfect roundness. Rear face of tyre is smooth as its sliced off after molding. Molded in Smooth-on Vitaflex 40 Poly Urethane resin to give a good grip on both wood and plastic. Urethane tyres don't require any oiling or special treatments. They will run on the track along side rubber and will not strip the grip as silicone can. Dimensions Size A diameter 20mm off the wheel x B width 14mm x C profile 3.6mm x D groove width 7mm, see image for info Safety - Please note these tyres are intended for slot racing purposes only, they are not a toy and should not be used by children under 12 years. They could be a choking hazard if swallowed Fitting guide The table below shows the cars the tyres are known to fit. These are confirmed as I own the cars, Will fit other models, please refer to the image to gauge the size your car needs. Note the outer diameter is very flexible and will stretch a lot to fit a wheel. I usually design the tyres slightly small so they have a nice secure seat on the wheel and don't require gluing. Manufacturer Make Model Position F3000 SCX/Scalextric Valvoline Rear Ferrari SCX/Scalextric 3C Rear Ferrari SCX/Scalextric F1 Rear Honda SCX/Scalextric Mclaren MP 4-4 Rear Indy SCX/Scalextric Pennzoil Rear M2000 SCX/Scalextric Single seat race car Rear Minardi SCX/Scalextric M-190 F1 Rear Yamaha SCX/Scalextric Jordan F1 Rear
Please take a look at our models, kits and figures
Thank you for looking