1.75 liter set of 2K car paint for Scania 1396114 Black Ebony Glossy Lackpoint
![](https://img.eselt.de/img/11665181_RtRrmHmru75PDfU6/thumb.jpg)
![](https://img.eselt.de/img/11665153_PtMAtPKAXEG5SKBT/thumb.jpg)
![](https://img.eselt.de/img/11665154_NIl2dHw0JR7Z56on/thumb.jpg)
Scope of delivery:
- 1 liter 2 component car paint Scania 1396114 Black Ebony Black in gloss
- 0.5 liter hardener for 2-component paint
- 0.25 liters of dilution
- 1 mixing cup for mixing
- 1 paint sieve 190my
- 1 pair of disposable gloves
After drying (approx. 48 hours at 20°C), has a high level of weather protection and is scratch-resistant.
An extra clear coat is not required. To increase the degree of gloss, a clear coat can be applied after it has completely dried (sanding and degreasing).
VOC regulation
Please note the new VOC regulation
From the 01. January 2007 the changes from the so-called "VOC regulation" (2004/42/EC or 1999/13/EC) take effect.
For us as a dealer, this means that we have to ensure that products that are not VOC-compliant, such as industrial paints, are only used for painting in the exceptional cases mentioned below.
These applications are:
- Restoration of vintage cars
- Filling of aerosol spray cans
- Painting of vehicles of the Bundeswehr, civil defense, fire brigade, as well as the forces responsible for maintaining order
- Painting of vehicles that are used in public service exclusively in the city area
- Industrial painting (e.g. plastic parts not related to the vehicle).
With the purchase you confirm that you are familiar with the legal situation of the ChemVOCFarbV and have been sufficiently informed about it by us - Lackpoint Dresden.
You also confirm that you will only use the products that you purchase from us that do not comply with the VOC limit values for the exceptional cases mentioned above.
The responsibility for the intended sale is hereby transferred from Lackpoint Dresden as the seller to you as the buyer.
processing
Before processing, the color must be checked (make a spray sample)
- Spray gun from 0.8 to 1.4mm (recommended 1.2-1.4mm)
- Note the temperature of at least 20°C
- Sand the surface to be painted with P500-P800 grit
- degrease well (silicone remover)
- When working on new or unpainted plastic surfaces, apply plastic primer and observe the drying times
- Apply filler or primer and allow to cure
- Smooth with an eccentric sander or wet sandpaper (caution! then let it dry well)
- Degrease again
- Painting - 2 to 3 spray coats
- The paint is dust-dry after 20-30 minutes. Dried through after 48 hours and fully cured after 3-4 days.
If you have any questions about processing, we are at your disposal.